6-4. DRIVE AUTO ADJUSTMENT1. DVD-SL (single layer)
Select [1], insert DVD single layer disc[ENTER], and press key,
On the Test Mode Menu screen, press [1] key on the remote com-and the adjustment will be made through the following steps, then
mander, and the drive auto adjustment menu will be displayed.adjusted values will be written to the EEPROM.
## Drive Auto Adjustment ##DVD Single Layer Disc Adjustment Steps
1. SLED TILT Reset
Adjustment Menu2. Disc Check Memory SL
3. Wait 500 msec
0. ALL
1. DVD-SL4. Set Disc Type SL
5. LD ON
2. CD6. Spdl Start
3. DVD-DL
4. SACD7. Wait 1 sec
8. Focus Search ON
9. Focus Search OFF
10. Focus Servo ON 1
Exit: RETURN11. Auto Track Offset Adjust
12. Tracking ON
Normally[0], is selected to adjust DVD (single layer), CD, DVD13. CLVA ON
(dual layer), and SACD in this order. But, individual items can be14. Wait 1 sec
adjusted for the case where adjustment is suspended due to an
15. Sled ON
error. In this mode, the adjustment can be made easily through the16. Check CLV Lock
operation following the message displayed on the screen.17. Auto LFO Adjust
The disc used for adjustment must be the one specified for adjust-
18. Auto Focus Offset Adjust
ment. However, for SACD disc, use the player with initial data if19. Auto Tilt Position Adjust
the disc is not available.
20. Auto Focus Gain Adjust
21. Auto Focus Offset Adjust
0. ALL22. EQ Boost Adjust
You will be asked if EEPROM data are initialized or not, and for
23. Auto LFO Adjust
this prompt, select [0] and press the [ENTER] key, and the servo24. Auto Track Gain Adjust
set data in EEPROM will be initialized. Then, 1. DVD-SL disc, 2.25. All Servo Stop
CD disc, 3. DVD-DL disc, and 4. SACD disc are adjusted in this
26. Eep Copy Loop Filter Offset
order. Each time one disc was adjusted, it is ejected. Replace it
with the specified disc following the message. Though the mes-
sage to confirm whether discs other than SACD disc are adjusted
is not displayed, you can finish the adjustment if pressing the
[STOP] button. The S curve level, RF level, and jitter value can
be confirmed during adjustment, and if OK, press the [ENTER]
key and continue adjustment. (If NG[STOP], pr bess the utton)
During adjustment of each disc, the measurement for disc type
judgment is made. As automatic adjustment does not judge the
disc type unlike conventional models, take care not to insert wrong
type discs. Also, do not give a shock during adjustment.
6-5 |
ACEC
