your TV to the player?s COMPONENT
VIDEO OUT jacks using a component
Additional Informationvideo cord (page 18).
, Even if your TV is compatible with
progressive format (480p) signals, the
Troubleshootingimage may be affected when you set the
player to progressive format. In this case,
set the NORMAL/PROGRESSIVE switch
If you experience any of the following
difficulties while using the player, use this to NORMAL so that the PROGRESSIVE
indicator turns off and the player is set to
troubleshooting guide to help remedy the normal (interlace) format.
problem before requesting repairs.
Should any problem persist, consult your
nearest Sony dealer (for customers in the Even though you set the aspect ratio in ?TV
USA only).TYPE? of ?SCREEN SETUP,? the picture
does not fill the screen.
Power, The aspect ratio of the disc is fixed on your
DVD.
The power is not turned on.
, Check that the AC power cord is connected
securely.Sound
There is no sound.
Picture, Re-connect the connecting cord securely.
, The connecting cord is damaged.
There is no picture/picture noise appears., The player is connected to the wrong input
, Re-connect the connecting cord securely.jack on the amplifier (receiver) (page 22,
, The connecting cords are damaged.23, 24).
, Check the connection to your TV (page 18) , The amplifier (receiver) input is not
and switch the input selector on your TV so correctly set.
that the signal from the player appears on , The player is in pause mode or in Slow-
the TV screen.motion Play mode.
, The disc is dirty or flawed., The player is in fast forward or fast reverse
, If the picture output from your player goes mode.
through your VCR to get to your TV or if , If the audio signal does not come through
you are connected to a combination TV/the DIGITAL OUT (COAXIAL) jack,
VIDEO player, the copy-protection signal check the audio settings (page 68).
applied to some DVD programs could affect , While playing a Super VCD on which the
picture quality. If you still experience audio track 2 is not recorded, no sound will
problems even when you connect your come out when you select ?2:STEREO,?
player directly to your TV, please try ?2:1/L,? or ?2:2/R.?
connecting your player to your TV?s S
VIDEO input (page 18).
Sound distortion occurs.
, You set the NORMAL/PROGRESSIVE , Set ?AUDIO ATT? in ?AUDIO SETUP? to
switch to PROGRESSIVE on the rear panel
(the PROGRESSIVE indicator lights up) ?ON? (page 68).
even though your TV cannot accept the
progressive signal. In this case, set the The sound volume is low.
NORMAL/PROGRESSIVE switch to , The sound volume is low on some DVDs.
NORMAL on the rear panel so that the The sound volume may improve if you set
PROGRESSIVE indicator turns off.?AUDIO DRC? to ?TV MODE? (page 68).
, You set the NORMAL/PROGRESSIVE , Set ?AUDIO ATT? in ?AUDIO SETUP? to
switch to PROGRESSIVE on the rear panel ?OFF? (page 68).
(the PROGRESSIVE indicator lights up)
but did not connect your TV to the player?s
COMPONENT VIDEO OUT jacks using a
COMPONENT VIDEO cord. Set to the
PROGRESSIVE only when you connect
70 |
ACEC
