6-4. DRIVE AUTO ADJUSTMENT1. DVD-SL (single layer)
Select [1], insert DVD single layer disc[ENTER], and press key,
On the Test Mode Menu screen, press [1] key on the remote com-and the adjustment will be made through the following steps, then
mander, and the drive auto adjustment menu will be displayed.adjusted values will be written to the EEPROM.
## Drive Auto Adjustment ##DVD Single Layer Disc Adjustment Steps
Adjustment Menu1. SLED TILT Reset
2. Disc Check Memory SL
0. ALL
1. DVD-SL3. Set Disc Type SL
4. Spdl Start
2. CD5. Wait 1 sec
3. DVD-DL
4. LCD6. LD ON
7. Focus Error Check
8. Focus ON 0
9. Auto Track Offset Adjust L0
Exit: RETURN10. Trv Level Check
11. Tracking ON
Normally[0], is selected to adjust DVD (single layer), CD, DVD12. Wait 100 msec
(dual layer), and LCD (SACD) in this order. But, individual items13. CLVA ON
can be adjusted for the case where adjustment is suspended due to
14. Wait 500 msec
an error. In this mode, the adjustment can be made easily through15. Sled ON
the operation following the message displayed on the screen. Which16. Auto Loop Filter Offset Adjust
disc is currently adjusted is displayed on the fluorescent display
17. Auto Focus Gain Adjust L0
tube.18. Auto Focus Balance Adjust L0
The disc used for adjustment must be the one specified for adjust-
19. EQ Boost Adjust
ment.20. Auto Loop Filter Offset Adjust
21. RF Level Measure
0. ALL
22. Jitter Disp ON
You will be asked if EEPROM data are initialized or not, and for23. Jitter Memory
this prompt, select [0] and press the [ENTER] key. First , the servo24. Jitter Disp OFF
setting data in EEPROM, Emergency History and Hour Meter are
25. Eep Copy Loop Filter Offset
cleared to initialize. Then, 1. DVD-SL disc, 2. CD disc, 3. D26. All Servo StopVD-
DL disc, and 4. LCD disc (SACD disc) are adjusted in this order.
Each time one disc was adjusted, it is ejected, and therefore ex-
change the disc following the message. Though the message to
confirm whether the discs is to be adjusted is not displayed except
for LCD disk (SACD disk), you can exit the adjustment by press-
ing the [STOP] button. In adjusting each disc, the mirror time is
measured to check the disk type. In the auto adjustment, whether
the disc type is correct is not checked unlike conventional models,
and accordingly, take care not to insert a different type of disc.
6-5 |
ACEC
