Controlling the TV3Release ?/1.
When you set the TV/DISC EXPLORER/DVD switch to
TV, you can control your TV using the buttons below.Code numbers of controllable AV receivers
(amplifier)
Set the TV/DISCIf more than one code number is listed, try entering them
?/1
EXPLORER/DVDone at a time until you find the one that works with your
switch to TV.VOLAV receiver (amplifier).
123
Number456CH
MEGA
buttons789
0TV/VIDEOManufacturerCode number
ABCDALL
ENTERWIDE MODE
FILE SORTEDIT DVDCDSony91 (default), 89
LOAD
Denon84, 85, 86
Kenwood92, 93
Onkyo81, 82, 83
ENTER
Settings and Adjustments
Pioneer99
Sansui87
Technics97, 98
By pressingYou canYamaha94, 95, 96
?/1Turn the TV on or off
Notes
TV/VIDEOSwitch the TVOs input source betweenY If you enter a new code number, the code number previously
the TV and other input sources
entered will be erased.
VOLAdjust the volume of the TVY When you replace the batteries of the remote, the code number
may be reset to the default setting. Reset the appropriate code
CHSelect the channel of the TVnumber.
WIDE MODESwitch the wide picture on or off
Controlling the AV receiver (amplifier)
Number buttonsSelect the channel of the TV
When you set the TV/DISC EXPLORER/DVD switch to
and ENTER
DVD, you can change the volume of the AV receiver
(amplifier) using VOL.
Note
Depending on the TV, you may not be able to control your TV or
to use some of the buttons above.Set the TV/DISC
EXPLORER/DVD
switch to DVD.123
VOL
4 56
Controlling AV receivers (amplifiers) with
789MEGA
the remote0
ABCDALL
FILE SORTEDIT DVDCD
Set the TV/DISC
LOAD
EXPLORER/DVD
?/1
switch to DVD.
123
Number456
buttons789MEGA
0
ABCDALL
FILE SORTEDIT DVDCD
LOAD
Note
1Slide the TV/DISC EXPLORER/DVD switch to DVD.
Depending on the AV receiver (amplifier), you may not be able to
control your AV receiver (amplifier).
2Hold down ?/1, and enter your AV receiverOs
manufacturerOs code (see the table) using the
number buttons.
73 |
ACEC
