Installing the USB driver
Before connecting your camera to your personal computer, install the USB driver to
the computer. The USB driver is contained together with application software for
viewing images on a CD-ROM which is supplied with your camera.
For Windows 98 users
1Turn on your personal computer and allow Windows98 to load.
2Insert the supplied CD-ROM in the CD-ROM drive of your personal
computer.
3Connect the USB jack on your camera with the USB connector on
your personal computer using the supplied USB cable.
to the USB connector to the USB jack
Push in until the
USB cableconnector clicks
Personal computerinto place
4Insert a ?Memory Stick? into your camera, connect the AC power
adaptor/charger and turn on your camera.
?PC MODE? appears on the LCD screen of your camera and the camera is set
to communication standby mode. Your personal computer recognizes the
camera, and the Windows 98 Add Hardware Wizard starts.
5Follow the on-screen messages to specify the CD-ROM drive and
install the USB driver.
The Add Hardware Wizard starts twice because two different USB drivers are
installed. Be sure to allow the installation to complete without interrupting it.
Note
Be sure to insert a ?Memory Stick? into your camera before installing the USB driver.
Otherwise, you will be unable to install the USB driver.
For Macintosh users
1Turn on your personal computer and allow the MacOS to load.
2Insert the supplied CD-ROM in the CD-ROM drive of your personal
computer.
26 |
ACEC
