http://getMANUAL.com
Deleting an edit point6-1-5 Cue-up to Edit Points and
Preroll
To delete an edit point, use the following procedure.
You can use the same procedure whether or not theTo preroll to an edit IN point or cue up to any edit
DELETE button is flashing.
point, use the following procedure.
2121
1Press the RECORDER button or PLAYER button1Press the RECORDER button or PLAYER button
to select the VTR on which you wish to delete theto select the VTR on which you wish to operate.
edit point.
The button you have pressed lights.
The button you have pressed lights.Chapter 6Editing Without Using the Built-in Hard Disk (Two-VTR Editing)
2YTo cue up to an edit point
2Hold down the DELETE button and press the INHold down the IN button or OUT button
button or OUT button according to the edit point
according to the edit point to which you wish to
you wish to delete.cue up, and press the PREROLL button.
The IN point or OUT point is deleted according toThis cues up to the edit point you have selected.
which button you pressed, and the DELETE button
goes off.
YTo preroll
Press the PREROLL button.
To restore a deleted edit point
To restore an edit point immediately after deleting it,The tape is wound back to a position 5 seconds
hold down the IN button or OUT button according to
the edit point you wish to restore, and press thebefore the edit IN point, and stops.
RECALL button.To change the preroll time
The factory default setting for the preroll time is 5
seconds, but you can use basic menu item 001 to
change this to any value from 0 to 30 seconds. If you
change the preroll time, make sure that the setting is
not longer than the recording length before the edit IN
point.
Note that for automatic editing, the preroll time setting
on the recorder takes precedence.
For more information about the basic menu, see Section 7-2,
OBasic Menu� (page 7-1).
Chapter 6 Editing Without Using the Built-in Hard Disk (Two-VTR Editing)6-5 |
ACEC
