5-3-3 Standalone Editing6At the editing end point (the recorder OUT point),
press the PLAY button.
This refers to editing using as the player an external
Editing ends, and the recorder continues with
device which cannot be controlled remotely through
playback.
the REMOTE1-IN(9P) connector. For example, you
can record a color bar signal from a signal generator in7Press the STOP button to stop the recorder
the joints between the scenes of an already completed
playback.
tape.
Carrying out standalone editing
First use the VIDEO INPUT SELECT switch to select5-3-5 Preread Editing
the signal being generated by the signal generator
connected to the unit, then with both the PLAYER
Video and digital audio signals already recorded on the
button and RECORDER button off, set the IN point.tape can be used as an edit source for insert editing.
The AUTO EDIT button flashes, and it is now possibleThis type of editing is called Opreread editing�, as the
to carry out automatic editing.VTR uses the preread heads to read the signals in
If necessary, you can also first set the OUT point.advance from the tape.
The signals read out can be send to a mixer for mixing,
and can be recorded either on the original channels or
on other digital audio channels.Chapter 5Editing
5-3-4 Manual Editing
For preread editing, press the PREREAD button,
turning the indicator on.
Use the following procedure to carry out manual
editing.
1Press the RECORDER button, turning theVideo source
indicator on.
Digital or analog
video output
2Use the search dial in jog or shuttle mode to findVideo switcher
the editing start point (the recorder IN point), and
Digital or analog
stop the tape just before this point.video input
Note
If the recorder is in stop mode, then when editing
starts this section of the video will break up.
3Select the editing mode.
4Press the PLAY button.
Digital or analog
audio input
The recorder begins playback.
Audio mixer
NoteDigital or analog
audio output
It takes about two seconds until the playback video
stabilizes. For this reason, start the playback from
Audio source
before the segment of video you wish to use.
5At the editing start point (the recorder IN point),
press the EDIT button and PLAY button
simultaneously.
Editing starts.
Chapter 5 Editing5-13 |