When using the connecting cord
Presetting radio stationsIf the sound is distorted, connect the device to the i jack.Troubleshooting
F
You can preset up to 51 stations: 30 for FM, 10 for AM, 7Should any problem persist after you have made these
About the G-PROTECTION and SOUND
for TV, and 4 for WB.checks, consult your nearest Sony dealer.
functions when using the connecting
cordCHARGE lamp flashes on the CD player
Presetting stations manually
Y To record high quality CD sound, set thewhen you press a button, and the CD
1Press RADIO ON/OFF to turn on the radio.G-PROTECTION switch to OOFF.�does not play.
Y The SOUND function works only on the output soundcThe buttons are locked. Slide HOLD back.
2Press the jog lever to select a radio band.
LINE OUTfrom the i jack and not work on the output sound from
3Flick the jog lever toward TUNE + or TUNE � to tunethe LINE OUT jack.The CD player does not start charging.
in to the station you want.cDuring stop, press CHARGE/x.
4Hold down the jog lever for 2 seconds or more untilcYou press x on the remote control. Press CHARGE/x
OPRESET� appears in the display.Precautionson the CD player.
The preset number and OM� flash in the display.cThe radio is turned on.
On safety
From this step on, start the next operation within 15You cannot preset stations automati-
Y Should any solid objects or liquid fall into the CD
seconds after you finished the previous operation. Ifcally.
player, unplug it and have it checked by qualified
15 seconds pass with nothing done, OPRESET� and
personnel before operating it any further.cPreset stations manually.
the preset number disappear which shows that the CD
Connecting cordY Do not put any foreign objects in the DC IN 4.5 V
player has exited the presetting mode. If this happens,The volume does not increase even if
(external power input) jack.start again from step 4.you press VOL + repeatedly.
Left (white)5Flick toward TUNE + or TUNE � repeatedly to selectOn power sourcescSet AVLS to ONORM.�
the preset number you want to use to store the station.Y When you are not using the CD player for a long time,
Right (red)disconnect all power sources from the CD player.The battery compartment lid is
6Press the jog lever.dettached by an accidental drop,
When the station is preset successfully, a beep soundsOn AC power adaptorexcessive force, etc.
and OPRESET� and the preset number disappear fromY Use only the AC power adaptor supplied. If your CDcAttach it as illustrated below.
the display. If there is a station already stored usingplayer is not supplied with the one, use the AC-E45HG
Stereo system,that number, the new station replaces the old one.AC power adaptor. Do not use any other AC power
cassette recorder,adaptor. It may cause a malfunction.
radio cassettePresetting stations automatically
recorder, etc.Polarity of the plug
1Press RADIO ON/OFF to turn on the radio.
2Press the jog lever to select a radio band.
3Hold down DISPLAY until OA Preset� appears in the
display.
Y Do not touch the AC power adaptor with wet hands.
Using the radio4Press the jog lever.Y Connect the AC power adaptor to an easily accessibleSpecifications
The CD player starts scanning the stations from theAC outlet. Should you notice an abnormality in the ACCD player
Using the remote control, you can enjoy TV, WBlower frequencies and stops when a station ispower adaptor, disconnect it from the AC outlet
(Weather band), FM and AM programs by presetting thereceived.immediately.System
stations or by tuning in to the stations manually.While scanning, OA� flashes in the display.
Compact disc digital audio system
You can preset automatically scanned stations or selectOn rechargeable batteries and dry
your favorite stations manually.batteriesLaser diode propertiesWhen all the receivable stations are preset, a beep
sounds and OA� stops flashing,
Y Do not charge the dry batteries.Material: GaAlAs
To stop scanningY Do not throw the batteries into fire.Wavelength: ? = 780 nm
Listening to the radioY Do not carry the batteries with coins or other metallicEmission duration: Continuous
Press RADIO ON/OFF or press x on the remote control.
objects. It can generate heat if the positive and negativeLaser output: Less than 44.6 ?W (This output is the value
1Press RADIO ON/OFF to turn on the radio.The radio is turned off at that time.
terminals of the battery are accidentally contacted by ameasured at a distance of 200 mm from the objective lens
If OPRESET� is displayed, press P MODE/ tometallic object.surface on the optical pick-up block with 7 mm aperture.)
make it disappear from the display.Playing preset radioY Do not mix rechargeable batteries with dry batteries.
Y Do not mix new batteries with old ones.Radio
2Press the jog lever of the remote control until the
stationsY Do not use different types of batteries together.
radio band you want appears.
Y When the batteries are not to be used for a long time,Frequency range
Each time you press the button, the display on theremove them.1Press RADIO ON/OFF to turn on the radio.
10 kHz step:
remote control changes as follows:2Press the jog lever of the remote control to select aYIf battery leakage occurs, wipe off any deposit in theTV: 2 - 13 ch
t FM tAM t TV t WBradio band.battery compartment, and install new batteries. In caseWB (weather band): 1 - 7 ch
3Press P MODE/ to switch your CD player to thethe deposit adheres to you, wash it off thoroughly.FM: 87.5 - 108.0 MHz
3Flick the jog lever of the remote control towardpresetting mode.AM: 530 - 1 710 kHz
On the CD player
TUNE + or TUNE � to tune in the station you want4 Flick the jog lever toward TUNE + or TUNE � to tuneY Keep the lens on the CD player clean and do not touch9 kHz step:
and adjust the volume.in to the stored station you want to listen to.it. If you do so, the lens may be damaged and the CDTV: 2 - 13 ch
WB (weather band): 1 - 7 ch
player will not operate properly.
To turn off the radioFM: 87.5 - 108.0 MHz
Y Do not put any heavy object on top of the CD player.
Press RADIO ON/OFF again.If you press P MODE/ again, OPRESET�AM: 531 - 1 710 kHz
The CD player and the CD may be damaged.
disappears from the display and you can tune in to a
To tune in to a station quicklyY Do not leave the CD player in a location near heatAntenna
station manually.
Flick and hold the jog lever toward TUNE + or TUNE �sources, or in a place subject to direct sunlight,TV/WB/FM: Headphones/earphones cord antenna
in step 3 until the frequency digits begin to change in theexcessive dust or sand, moisture, rain, mechanicalAM: Ferrite bar antenna built in the remote control
display. The CD player automatically scans the radioshock, unleveled surface, or in a car with its windows
Changing the tuning
frequencies and stops when it finds a clear station.closed.General
intervalY If the CD player causes interference to the radio or
To improve broadcast receptiontelevision reception, turn off the CD player or move itPower requirements
When using the CD player abroad, change the AM tuning
For TV/WB/FM, extend the headphones or earphonesaway from the radio or television.
interval, if necessary.For the area code of the model you purchased, check the
cord.Y Discs with non-standard shapes (e.g., heart, square, star)upper left side of the bar code on the package.
Headphones or earphones1Press RADIO ON/OFF to turn on the radio.cannot be played on this CD player. Attempting to do soY Two Sony NH-7WMAA rechargeable batteries: 1.2 V
2Hold down DISPLAY until OA Preset� appears in themay damage the CD player. Do not use such discs.DC � 2
display.Y Sony NH-WM2AA rechargeable batteries: 1.2 V DC �
This warranty is valid only in the United States.
3Flick the jog lever toward TUNE + or TUNE � On headphones/earphones2
repeatedly until OStep� appears in the display.Y Two LR6 (size AA) batteries: 1.5 V DC � 2
Road safetyY AC power adaptor (DC IN 4.5 V jack):
For AM, reorient the remote control itself.4Press the jog lever.
Do not use headphones/earphones while driving, cycling,U, U2, CA, CA2, E92, MX2, TW2 and CA2/C models:
OStep 9k� or OStep 10k� appears in the display.
or operating any motorized vehicle. It may create a traffic120 V, 60 Hz
5Flick the jog lever toward TUNE + or TUNE � tohazard and is illegal in some areas. It can also beCED, CED/4, CE7, CE7/C, EE, EE1, E, E13 and E13/2
select the tuning interval.potentially dangerous to play your headsets at highmodels: 220 - 230 V, 50/60 Hz
volume while walking, especially at pedestrian crossings.CEK model: 230 V, 50 Hz
You should exercise extreme caution or discontinue use in9 kHz area: Asia and EuropeAU2 model: 240 V, 50 Hz
potentially hazardous situations.EU8, EU8/C, JE.W, E18, KR4 and EE8 models:
10 kHz area: the U.S.A., Canada and South America
Note100 - 240 V, 50/60 Hz
Preventing hearing damage
There is a DC-DC converter attached to the headphones/NoteHK4 model: 230 V, 50 Hz
Avoid using headphones/earphones at high volume.
earphones cord.CNA model: 220 V, 50 Hz
After changing the tuning interval, you need to preset rHearing experts advise against continuous, loud andadio
stations again.extended play. If you experience a ringing in your ears,Dimensions (w/h/d) (without projecting
reduce volume or discontinue use.parts and controls)
Connecting a stereo systemConsideration for othersApprox. 136.0 � 19.6 � 136.0 mm (5 3�8 � 25�32 � 5 3�8 in.)
When listening to an AM program, keep the remote
control away from the DC-DC converter, otherwise, noise may(F)Keep the volume at a moderate level. This will allow youMass (excluding accessories)
be heard.to hear outside sounds and to be considerate to the peopleApprox. 158 g (5.6 oz)
You can listen to CDs through a stereo system and record
around you.
If it is hard to hear an FM broadcastCDs on a cassette tape. For details, see the instructionOperating temperature
Press SOUND repeatedly until OLocal� appears in the5!C - 35!C (41!F - 95!F)manual that comes with the connected device.
display.MaintenanceBe sure to turn off all connected devices before making
Under the normal conditions, press SOUND repeatedlyconnections.Design and specifications are subject to change without
until ODX� appears in the display.To clean the casingnotice.
Notes
Use a soft cloth slightly moistened in water or a mild
Y Before you play a CD, turn down the volume of thedetergent solution. Do not use alcohol, benzine or thinner.
connected device to avoid damaging the connectedSupplied Accessories
speakers.To clean the plugs
AC power adaptor (1)
Y Use the AC power adaptor for recording. If you use theIf the plugs become dirty, there is no audio or noise is
Headphones/earphones (1)
rechargeable batteries or dry batteries as a power source,heard. Clean them with a dry soft cloth periodically.
Remote control with built-in tuner (1)
batteries may become completely depleted during
Rechargeable batteries (2)
recording.
Battery carrying case (1)
Y Adjust the volume properly on the connected device so
Carrying pouch (1)
that the sound will not be distorted.
Y When the CD player is connected to a stereo system,
you cannot listen to the radio. |
ACEC
