using the A/V connecting cable. However, the sound
you have recorded afterwards is not outpu9t fTourom chthe [AUDIO DUB].
speaker. Check the sound by using the headphones
A green X mark appears on the LCD
or a TV.
screen.
0:00:00:00
Recording sound AUD DUB CTRL
AUDIO
DUB
1Insert a recorded cassette into your
camcorder.
10Touch (play) and start playing
back the audio you want to record at
2Slide the POWER switch repeatedly to the same time.
select the PLAY/EDIT mode.A red mark remains on the LCD screen
while recording sound.
The new sound is recorded in stereo 2 (ST2)
3Touch (play/pause) to play thedu ring the playback of the tape.
tape.
11Touch (stop) when you want to
4Touch (play/pause) again at thset op recording.
point where you want to start To dub on other scenes, repeat steps 3 and 4
recording the sound.to select scenes, then touch [AUDIO DUB].
The playback pauses.
12Touch , then .
5Touch .
To set the end point for audio dubbing
6Touch [MENU].
During playback, press ZERO SET MEMORY
on the Remote Commander at the scene at
which you want to stop audio dubbing. Then,
7Touch / to select (EDIT/
perform steps 4 to 10. The recording stops
PLAY), then touch .
automatically at the selected scene.
b Note
8Touch / to select [AUD DUB
You can only record additional audio over a tape
CTRL], then touch .
recorded on your camcorder. The sound may
deteriorate when you dub audio on a tape recorded
0:00:00:00on other camcorders (including other DCR-HC65/
AUD DUB CTRL
HC85 camcorders).
AUDIO
DUB
106Dubbing/Editing |
ACEC
