Y When you move the system, take out any discs.
If you donOt, the disc may be damaged.
Y For power saving purposes, the system can bePrecautions
completely turned off by the POWER button
on the main unit. Though the LED remains lit
On safetyfor a while, the system is completely off.
Y Caution � The use of optical instruments with
this product will increase eye hazard.On adjusting volume
Y Should any solid object or liquid fall into theDo not turn up the volume while listening to a
cabinet, unplug the system and have it checkedsection with very low level inputs or no audio
by qualified personnel before operating it anysignals. If you do, the speakers may be damaged
further.when a peak level section is played.
On power sourcesOn cleaning
Y The unit is not disconnected from the Clean the cabinet, panel, and controls with a softAC power
source as long as it is connected to the wallcloth slightly moistened with a mild detergent
outlet, even if the unit itself has been turned ofsolution. Do not use any type of abrasive pad,f.
Y AC power cord must be changed only at thescouring powder or solvent such as alcohol or
qualified service shop.benzine.
If you have any questions or problems concerning
On placementyour system, please consult your nearest Sony
Y Place the system in a location with adequatedealer.
ventilation to prevent heat build-up in the
system.On cleaning discs
Y At high volume, over long periods of time, theDo not use a commercially available CD/DVD
cabinet becomes hot to the touch. This is not acleaning disc. It may cause a malfunction.
malfunction. However, touching the cabinet
should be avoided. Do not place the unit in aOn your TVOs color
confined space where ventilation is poor as thisIf the speakers should cause the TV screen to have
may cause overheating.color irregularity, turn off the TV at once then
Y Do not block the ventilation slots by puttingturn it on after 15 to 30 minutes. If color
anything on the system. The system isirregularity should persist, place the speakers
equipped with a high power amplifier. If thefurther away from the set.
ventilation slots on the top surface are blocked,
the unit can overheat and malfunction.
Y Do not place the system on a soft surface suchIMPORTANT NOTICE
as a rug that might block the ventilation holesCaution: This system is capable of holding a
on the bottom.still video image or on-screen display image on
Y Do not place the system in a location near heatyour television screen indefinitely. If you leave
sources, or in a place subject to direct sunlight,the still video image or on-screen display image
excessive dust, or mechanical shock. displayed on your TV for an extended period of
time you risk permanent damage to your
On operationtelevision screen. Projection televisions are
Y If the system is brought directly from a cold toespecially susceptible to this.
a warm location, or is placed in a very damp
room, moisture may condense on the lenses
inside the system. Should this occur, the
system may not operate properly. In this case,
remove the disc and leave the system turned on
for about half an hour until the moisture
evaporates.
4 |
ACEC
