Adjusting the convergence Adjusting the picture quality
(CONVERGENCE)(SCREEN)
The CONVERGENCE settings allow you to adjust the quality of The SCREEN settings allow you to degauss (demagnetize) the
the picture by controlling the convergence. The convergence monitor manually and adjust the picture quality by controlling the
refers to the alignment of the red, green, and blue color signals.moire and landing.
If you see red or blue shadows around letters or lines, adjust the If the color is not uniform or picture is fuzzy, degauss the
convergence.monitor (DEGAUSS).
These settings are stored in memory for all input signals. If elliptical or wavy patterns appear on the screen, cancel the
moire (CANCEL MOIRE).
1Press the MENU button.The monitor is automatically demagnetized (degaussed) when the
The menu appears on the screen.power is turned on.
The screen is degaussed for about 2 seconds. If a second degauss
2Move the control button up or down to highlight cycle is needed, allow a minimum interval of 20 minutes for the
CONVERGENCE and press the control button.best result.
The CONVERGENCE menu appears on the screen.
The CANCEL MOIRE setting is stored in memory for the current
3Move the control button up or down to select the input signal. All other settings are stored in memory for all input
desired adjustment item. Then press the control signals.
button.
The adjustment bar appears on the screen.1Press the MENU button.
The menu appears on the screen.
4Move the control button up or down to make the
adjustment. Then press the control button.2Move the control button up or down to highlight
SCREEN and press the control button.
SelectToThe SCREEN menu appears on the screen.
US
horizontally shift red or blue shadows
3Move the control button up or down to select the
vertically shift red or blue shadowsdesired adjustment item. Then press the control
button.
vertically shift red or blue shadows at the top of
TThe adjustment bar appears on the screen.
TOPthe screen
4Move the control button up or down to make the
vertically shift red or blue shadows at the bottom
B
adjustment. Then press the control button.
BOTTOMof the screen
0 reset all the CONVERGENCE adjustments to
RESETthe factory setting levels. Select OK.
For more information about using the RESET mode, see
?Resetting the adjustments (RESET)? on page 17.
(continued)
13 |
ACEC
