D:\###sagyou\08 gatu\0827-y\386760621CPD-G400\01US03BAS-UC.fmmasterpage:Left
Locking the controls
Helpful hints and information
To protect adjustment data by locking the controls, first
move the control buttonm/M to select (CONTROL (HELP)
LOCK). Then move the control button,, to sel ect ON.
Only th1e (p ower) switch, EXIT, and (CONTROL LOCK) The HELP menu contains helpful hints and information about this
of the OPTION menu will operate. If any other itemsmo are nitor.selecte If ydo, ur monitor is displaying symptoms that match those
the mark appears on the screen.listed in the HELP menu, follow the on-screen instructions to
resolve the problem. If the symptoms do not match those listed in
To cancel the control lockthe HELP menu or if the problem persists, see ?Trouble
Repeat the procedure above and set (CONTROL LOCK) to OFF.symptoms and remedies? on page 17.
Restoring the color
1Press the center of the control button.
The colors of most display monitors tend to gradually loThe maise brinllian MENU ce appears on the screen.
over several years of service. The IMAGE RESTORATION feature
allows you to restore the color to the original factory2 Mov quae thlity e colevelntrol bs. utton to highlight HELP and
The explanation below explains how to restore the monpressitor?s colo the cenr.ter of the control button again.
To restore the color, first move the conmt/rol buM tton The following HELP menu appears on the screen.
to select (IMAGE RESTORATION). Then move the
HELP
control button ,.
The picture disappears while the color is being restored (aboutRET 2 URN TO MA I N MENU
RECOMMENDED RESOLUT ION
seconds). After the color is restored, the picture reappears onFL tICKhEeR
TH I N HOR I ZONTAL L I NE
screen again.D I STORTED SHAPE
OUT OF FOCUS
D I SCOLORAT ION
Notes
? Before using this feature, the monitor must be in normal operation
mode (green power indicator on) for at least 30 minutes. If the monitor
3Move the control button m/M to select a HELP menu
goes into power saving mode, you must return the monitor to normal
item and press the center of the control button
operation mode and wait for 30 minutes for the monitor to be ready.
again.
You may need to adjust your computer?s power saving settings to keep
Instructions or information to resolve the problem appears on
the monitor in normal operation mode for the full 30 minutes. If the
the screen. An explanation of each menu item is given below.
monitor is not ready, the following message will appear.
OPT IONRECOMMENDED RESOLUTION
If the picture does not fill the screen to the edges or if the picture
AVA I LABLE
AFTERappears too large for the screen, adjust the resolution to the figures
WARM�UP
shown in the menu using your computer. If the input signal
matches one of this monitor?s factory preset modes, the resolution
IMAGE
RESTORAT IONand refresh rate of the current input signal are displayed.
RECOMMENDED RESOLUT ION
? The monitor may gradually lose its ability to perform this functiSEonT dRESue OLUT ION TO
to the natural aging of the picture tube.1280X1024 AT 85Hz US I NG PC .
CURRENT SETT I NG I S
1280X1024 AT 75Hz .
FLICKER
If the picture is flickering, adjust the refresh rate to figures shown
in the menu. If the input signal matches one of this monitor?s
factory preset modes, the refresh rate of the current input signal is
displayed.
FL I CKER
SET REFRESH RATE TO
75Hz OR 85Hz US I NG PC .
CURRENT SETT I NG I S 60Hz .
14
CPD-G400
3-867-606-21 (1) |
ACEC
