Additional information
On operation
Y If the system is brought directly from a cold to a
Precautionswarm location, or is placed in a very damp room,
moisture may condense on the lens inside the CD
player. Should this occur, the system will not
On operating voltage
operate properly. Remove the CD and leave the
Before operating the system, check that the operating
system turned on for about an hour until the
voltage of your system is identical with the voltage ofmoisture evaporates.
your local power supply.
YWhen you move the system, take out any discs.
On safety
If you have any questions or problems concerning
YThe system is not disconnected from the AC power
your stereo system, please consult your nearest Sony
source (mains) as long as it is connected to the wall
dealer.
outlet, even if the system itself has been turned off.
YUnplug the system from the wall outlet (mains) if itNotes on CDs
is not to be used for an extended period of time. To
YBefore playing, clean the CD with a cleaning cloth.
disconnect the cord (mains lead), pull it out by the
Wipe the CD from the center out.
plug. Never pull the cord itself.
YDo not use solvents.
YShould any solid object or liquid fall into the
YDo not expose the CD to direct sunlight or heat
component, unplug the stereo system and have the
sources.
component checked by qualified personnel before
operating it any further.YDiscs with non-standard shapes (e.g., heart, square,
Additional Information
star) cannot be played on this system. Attempting to
YThe AC power cord must be changed only at a
do so may damage the system. Do not use such
qualified service shop.
discs.
On placement
Note on CD-R/CD-RW playback
YPlace the system in a location with adequate
Discs recorded on CD-R/CD-RW drives may not be
ventilation to prevent heat build-up the system.
played back because of scratches, dirt., recording
YDo not place the system in an inclined position.
condition or the driveOs characteristics. Besides, the
YDo not place the system in locations where it is;
discs, which are not yet finalized at the end of
�Extremely hot or cold
recording cannot be played back.
�Dusty or dirty
�Very humidCleaning the cabinet
�VibratingUse a soft cloth slightly moistened with mild
�Subject to direct sunlight.detergent solution.
On heat buildupTo save a tape permanently
�Although the system heats up during operation, thisTo prevent a tape from being accidentally recorded
is not malfunction.over, break off the cassette tab from side A or B as
�Place the system in a location with adequateillustrated.
ventilation to prevent heat build-up in the system.
If you continuously use this system at a large volume,Break off the
the cabinet temperature of the top, side and bottomcassette tab of
rises considerably. To avoid burning yourself, do notside A
touch the cabinet.
To prevent a malfunction, do not cover the ventilation
hole for the cooling fan.
If you later want to reuse the tape for recording, cover
the broken tab with adhesive tape.
continued
19 |
ACEC
