Step 3: Presetting radio stations
(continued)Connecting optional
components
6Press +/� repeatedly to select the preset
number that you want.
This section explains how to connect a variety of
components to your system in order to enhance it.
Refer to the instructions included with each
component for details.
3 1005
Connecting audio components
Connecting an MD deck for
analog recording
You can connect an MD deck to the system with
commercially available audio cords. Be sure to
7Press ENTER.match the color-coded pins to the appropriate
jacks. To listen to the MD deck after connecting it,
The station is stored to the selected preset
number.press FUNCTION repeatedly until OMD� appears.
To the audio output jacks on
8Repeat steps 2 through 7 to preset otherthe MD deck
stations.
To tune in a weak station
In step 3, press TUNING MODE repeatedly until
OMANUAL� appears, then press +/� repeatedly to
tune in the station.
To change the preset number
Start over from step 2.
Tip
The preset stations are saved in the systemOs memory
for about two days even if you disconnect the power
cord or a power failure occurs.
To change the AM tuningTo the audio input jacks on the MD
interval (not applicable on thedeck
European model)
The AM tuning interval is factory-preset to 9 kHz (or
10 kHz on North American model). To switch the
AM tuning interval, tune in any AM station first, then
turn off the system. Pressing TUNING + on the unit
down, turn the system back on. When you change the
interval, all the AM preset stations are erased. To
change back to the original interval, repeat the same
procedure.
10 |
ACEC
