Additional Information
On heat buildup
PrecautionsY Although the unit heats up during operation, this is
not a malfunction.
Y To prevent heat build-up in the system, place the
The nameplate is located on the bottom exterior.system in a location with adequate ventilation and
CAUTIONrefrain from placing anything on the top of the
cabinet.
Danger of explosion if battery is incorrectly replaced.
If you continuously use this system at a large volume,
Replace only with the same or equivalent typethe cabinet temperature of the top, side and bottom
recommended by the manufacturer. Discard used
rises considerably. To avoid burning yourself, do not
batteries according to the manufacturers instructions.touch the cabinet.
On operating voltageTo prevent a malfunction, do not cover the ventilation
hole for the cooling fan.
Before operating the system, check that the operating
voltage of your system is identical with the voltage ofOn operation
your local power supply.
Y If the system is brought directly from a cold place
On safetyto a warm place, or is placed in a very damp room,
moisture may condense on the lens inside the CD
Y The unit is not disconnected from the AC power
source (mains) as long as it is connected to the wallplayer or the MD deck. Should this occur, the
system will not operate properly. Remove the CD or
outlet, even if the unit itself has been turned off.
MD and leave the system turned on for about an
Y Unplug the system from the wall outlet (mains) if ithour until the moisture evaporates.
will not be used for an extended period of time. To
Y When moving the unit, remove any disc that may be
disconnect the power cord (mains lead), pull it outin the system.
by the plug. Never pull the cord itself.
Y Should any solid object or liquid fall into the
system, unplug the system and have it checked byIf you have any questions or problems concerning
qualified personnel before operating it any further.your system, please consult your nearest Sony dealer.
Y AC power cord must be changed only at theOn the speaker system
qualified service shop.Although this speaker system is magnetically
On placementshielded, there may be cases where the picture on
Y Do not place the system in an inclined position.some TV sets becomes magnetically distorted. In
such a case, turn off the power of the TV set once,
Y Do not place the system in locations where it is:
Extremely hot or coldand after 15 to 30 minutes turn it on again.
If there seems to be no improvement, locate
Dusty or dirty
Very humidthe speaker system further away from the TV set.
Also, be sure not to place objects in which magnets
Subject to vibrations
are attached or used near the speaker system, such as
Subject to direct sunlightaudio racks, TV stands, and toys. These may cause
magnetic distortion to the picture due to their
interaction with the system.
54 |
ACEC
