English
Use TYPE I (normal) tape only.Use TYPE I (normal) tape only.
On operationTape PlayerDimensions
Approx. 420 ´ 165 ´ 256 mm (w/h/d)
Playing a tapeRecordingFalling asleep to musicY If the player is brought directly511
PrecautionsTroubleshootingSpecifications(16 �8 ´ 6 �2 ´ 10 �8 inches)(incl.Notice for customers in the
The tape does not move when you
from a cold to a warm location, orprojecting parts) WARNINGUnited Kingdom
press an operation button.
On safetyMass
is placed in a very damp room,GeneralA moulded plug complying with
Y Close the cassette compartmentCD player sectionApprox. 4.1 kg (9 lb. 1 oz) (incl.To prevent fire or shock
moisture may condense on theY As the laser beam used in the CDbatteries)BS 1363 is fitted to this equipment
The power does not come on.securely.Systemhazard, do not expose the
1Press TAPE (direct power-on).1Press xZ to open the tape compartment and insert a1Play the music source you want.player section is harmful to thelenses inside the CD playerCompact disc digital audio systemSupplied accessoryfor your safety and convenience.
Y Connect the mains lead securely.The REC z button does notplayer to rain or moisture.
eyes, do not attempt toblank tape.section. Should this occur, theLaser diode propertiesMains lead (1)
Y Make sure the batteries arefunction or the tape does not playMaterial: GaAlAsRemote control (1) (CFD-S32/S32L only)
disassemble the casing. Referplayer will not operate properly.CD RadioShould the fuse in the plug
Displayinserted correctly.or record.Wave length: 780 nmWith the side you want to
record on facing upwardIn this case, remove the CD andservicing to qualified personnelsupplied need to be replaced, sameDesign and specifications are subject to
Y Replace all the batteries with newEmission duration: ContinuousY Make sure the safety tab on theTo avoid electrical shock, do
only.wait about an hour for theLaser output: Less than 44.6 ?Wchange without notice.rating fuse approved by ASTA or
Cassette-
2Press SLEEP to display OSLEEP.�ones if they are weak.cassette is in place.not open the cabinet. Refer
Y Should any solid object or liquidmoisture to evaporate.(This output is the value measured at aBSI to BS 1362, (i.e. marked with
Y You cannot turn on the playerY Make sure "TAPE" appears in thedistance of about 200 mm from theOptional accessoriesservicing to qualified
Y If the player has not been used forfall into the player, unplug theor mark) must be used.
with the remote when you operateobjective lens surface on the opticaldisplay.Sony MDR headphone seriesCorder
player, and have it checked bya long time, set it in the playbackpick-up block with 7 mm aperture.)the player on batteries (CFD-S32/personnel only.
c
qualified personnel beforemode to warm it up for a fewPoor or distorted playback,Spindle speedS32L only).If the plug supplied with this
200 r/min (rpm) to 500 r/min (rpm)
minutes before inserting a(CLV)operating it any further.recording or erasing quality.Informationequipment has a detachable fuse
The power is not on, andOperating Instructions
cassette.Y Clean the heads, pinch roller andCleaning the cabinetNumber of channelsFor customers in Europecover, be sure to attach the fuse
"bAttErY" and "Error" are
capstan with a cleaning swab2cover after you change the fuse.
Y Clean the cabinet, panel anddisplayed alternately.slightly moistened with cleaningFrequency response
Never use the plug without the fuse
If you have any questions or
controls with a soft cloth slightly20 - 20,000 Hz +1/�2 dB
2Press xZ to open the tape compartment and insert aY Make sure the batteries arefluid or alcohol.problems concerning your player,cover. If you should lose the fuse
moistened with a mild detergentinserted correctly.Wow and fluttercover, please contact your nearest
recorded tape. Close the compartment.please consult your nearest SonyBelow measurable limitY Replace all the batteries with new
3Press SLEEP to select the minutes until the player goessolution. Do not use any type ofdealer.Y Replace all the batteries with newones if they are weak.Sony service station.
2Select the program source you want to record.
With the side you want tooff automatically.abrasive pad, scouring powder, orones if they are weak.Y TYPE II (high position) or TYPE
Radio section
play facing upwardsolvent, such as alcohol orIV (metal) tape is being used. Use
Each time you press the button, the indication changesThere is no audio.Frequency range
About this manual
To record from the CD playerbenzine.TYPE I (normal) tape only.
as follows: O60� n O90� n O120� n no indication nY Make sure the function you wantCFD-S22/S32
The instructions in this manual are
Press CD and insert a CD (See "Playing a CD").Y Demagnetize the heads using a
O10� n O20� n O30.�On power sourcesto use appears in the display.CFD-S22This Compact Disc player is
commercially available tape headFM87.5 - 108 MHzfor the CFD-S22, CFD-S22L, CFD-
Y For AC operation, check that theY Adjust the volume.classified as a CLASS 1 LASERS32, CFD-S32L and CFD-922L.
demagnetizer.or 87.6 - 108 MHz
cDisplayDisplayplayer's operating voltage isY Unplug the headphones whenCFD-S22Lproduct.Before you start reading, check
AM531 - 1,602 kHz
identical with your local powerlistening through speakers.Record/playback headThe CLASS 1 LASER PRODUCTyour model number. The CFD-S32L
supply (see "Specifications") andCapstanCFD-S22L/S32L/922LCFD-S32Noise is heard.is the model used for illustration
label is located on the bottom
purposes.
use the supplied mains lead; doFM87.5 - 108 MHz
Y Someone is using a portableCFD-S32Lexterior.
not use any other type.telephone or other equipment thatMW531 - 1,602 kHz
The voltage selector is located atemits radio waves near the player.Note
CFD-922L
LW153 - 279 kHzThe name of the switch to turn on/
the bottom of the player (fortMove the portable telephone,WARNING
3Press N.Brazilian model only).etc., away from the player.Erase headPinch rollerIFDo not install the appliance in aoff this player is indicated as below:
To record from the radioFM: 10.7 MHzSony Corporation ? 2000OOPERATE�: CFD-S22L/S32L/
confined space, such as a bookcase
To cancel the sleep functionY The player is not disconnected
Press RADIO BANDYAUTO PRESET and tune in theCD PlayerLensAM/MW/LW: 450 kHzor built-in cabinet.922L
from the AC power source
Press OPERATE (or POWER) to turn off the power.Aerials
station you want (See "Listening to the radio").OPOWER�:CFD-S22/S32
(mains) as long as it is connectedThe CD does not play or Ono dISC�FM: Telescopic aerial3-043-356-31(1)
to the wall outlet, even if thelights in the display even when aAM/MW/LW: Built-in ferrite bar
Noteaerial
player itself has been turned off.CD is in place.
DisplayWhen you are playing a tape using this function:
Y For battery operation, use six R20Y Make sure that the CDCassette-corder section
If the tape length of one side is longer than the set time, the player will
(size D) batteries.compartment is closed.
not go off until the tape reaches the end.Recording system
Y When the batteries are not to beY Place the CD with the label4-track 2 channel stereo
used, remove them to avoidsurface up.Fast winding time
ToPressApprox. 120 s (sec.) with Sony cassettedamage that can be caused byY Clean the CD.Choosing Power Sources
C-60
adjust the volumeVOLUME +, � (VOL +, � on thebattery leakage or corrosion.Y Take out the CD and leave the CDFrequency response
remote, CFD-S32/S32L only)Y The nameplate indicatingcompartment open for about anRemote (CFD-S32/S32L only)TYPE I (normal): 70 - 10,000 Hz
Connecting the mains leadUsing the player on batteries
operating voltage, powerhour to dry moisture
stop playbackxZcondensation.The remote does not function.General
consumption, etc. is located at theInsert one end of the supplied mains lead to the AC IN socket located at theInsert six R20 (size D) batteries (not supplied) into the battery compartment.
fast-forward or rewind the tapeM or mY Make sure "Cd" appears in theY Replace all the batteries in theSpeaker3Press z to start recording.bottom.rear of the player, and the other end to the mains.
display.remote with new ones if they areFull range: 10 cm dia., 3.2 ohms, cone
pause playbackX(N is depressed automatically.)type (2)Notes
On placementweak.
Press the button again to resume playThe sound drops out.OutputsY Replace the batteries when the OPR/BATT indicator dims or when the
Y Do not leave the player in aY Make sure that you are pointingHeadphones jack (stereo minijack)
Y Reduce the volume.the remote at the remote sensor onafter pause.player stops operating. Replace all the batteries with new ones. Before
location near heat sources, or in aFor 16 - 68 ohms impedance
eject the cassettexZY Clean the CD, or replace it if thethe player.headphonesyou replace the batteries, be sure to take out the CD from the player.place subject to direct sunlight,
CD is badly damaged.Maximum power outputY Remove any obstacles in the pathY To use the player on batteries, disconnect the mains lead from the player.
turn on/off the playerOPERATE (or POWER)excessive dust or mechanical2.3 W + 2.3 W
Y Place the player in a location freeof the remote and the player.
shock.Power requirements
from vibration.Y Make sure the remote sensor isFor CD radio cassette-corder:
Y Do not place the player on an
Notes on cassettesY Clean the lens with anot exposed to strong light suchBrazilian model:Inserting batteries into the remote
inclined or unstable place.
Y Break off the cassette tab from side A or B to prevent accidentalcommercially available blower.as direct sunlight or fluorescent110 - 120V, 220 - 240V AC(CFD-S32/S32L only)
Y Do not place anything within 10
recording. If you want to reuse the tape for recording, cover the brokenY The sound may drop out or noiselamp light.selectable, 50/60 Hz1 to AC IN
tab with adhesive tape.ToPressmm of the side of the cabinet. TheOther models:may be heard if the CD isY Move closer to the player when
ventilation holes must be230 V AC, 50 Hz
stop recordingxZrecorded using a personalusing the remote.9 V DC, 6 R20 (size D) batteries
unobstructed for the player tocomputer(CD-R,etc.).
Side AFor remote control (CFD-S32/S32L only):
pause recordingXoperate properly and prolong the3 V DC, 2 R6 (size AA) batteries
After trying the above remedies, if
Press the button again to resume recording.RadioPower consumption2 to the mains
life of its components.
you still have problems, unplug theAC 20 W
turn on/off the playerOPERATE (or POWER)Y If the player is left in a car parkedThe audio is weak or has poormains lead and remove all theBattery life
Tab for side Ain the sun, be sure to choose aquality.batteries. After all the indications inFor CD radio cassette-corder:
Tab for side B Insert two R6 (size AA) batteries (not supplied)
Tipslocation in the car where theY Replace all the batteries with newFM recordingthe display disappear, plug the
player will not be subjected to thepower cord and insert the batteries
Y Adjusting the volume or the audio emphasis will not affect theones if they are weak.
Y The use of a cassette with more than 90 minutes of play time is notagain. If the problem persists, pleaseSony R20P: approx. 13.5 hReplacing batteries
direct rays of the sun.recording level.Y Move the player away from the
recommended except for long, continuous recording or playback.consult your nearest Sony dealer.Sony alkaline LR20: approx. 20 hBrazilian model only: Adjusting the voltageWith normal use, the batteries should last for about six months. When the
Y Since a strong magnet is used forTV.
Y CFD-S22L/S32L/922L only: If the MW/LW program makes a
Be sure to set the VOLTAGE SELECTOR (at theremote no longer operates the player, replace all the batteries with new
whistling sound after you've pressed z in step 3, press PLAY MODEYthe speakers, keep personal creditTape playback
The picture of your TV becomes
MONO/ST ISS (Interference Suppress Switch) repeatedly until thecards using magnetic coding orSony R20P: approx. 7.5 hbottom) to your local power supply.ones.
unstable.
noise is at a minimum.spring-wound watches away from
Y If you are listening to an FMSony alkaline LR20: approx. 15 hNote
Y For the best results, use the AC power as a power source for recording.the player to prevent possible
program near the TV with anWhen you operate the player on batteries, you cannot turn on the player
CD playback
Y To erase a recording, proceed as follows:indoor antenna, move the playerusing the remote.damage from the magnet.
1 Insert a tape with the recording you want to erase.Sony R20P: approx. 2.5 haway from the TV.Tip
2 Press TAPE.Sony alkaline LR20: approx. 7 hOnly for the customers supplied with an AC plug adaptor:
3 Press z.Use the supplied AC plug adaptor if the plug of the main lead does not
match your outlet. |
ACEC
