Waking up to music (continued)
6Press TUNE TIME SET + or � to set the volume,
then DSPL ENT MEM.
Tips7Press STANDBY.
Y To exit the standby
The c indication lights up and the power goes off.
mode, press STANDBY
to make c disappear
At the preset time, the power will go on, and the
from the display.
music will play. Then the power will go off at the
Y The preset settings
preset time, and the player will enter into the
remain until you reset
standby mode.them.
Note
To check/change when the playback will start
When you press N or
z button of the tapePress TIMER, then DSPL ENT MEM. Each time you
player in the timerpress DSPL ENT MEM, a stored setting is displayed in
mode:the set order. To change the setting, display the setting
If the tape length ofyou want to change and re-enter it.
one side is longer than
the set time, the player
will be turned off at the
To use the player before a timer playback starts
end of the tape, not at
the set time.Just turn on the player, and then you can use it.
If you turn off the player before the preset time, timer
playback will start at the preset time.
In case of the radio, however, if you listen to the
station which is different from the one you tuned in
in step 1 on page 21, you will hear that station at the
preset time. Make sure to tune in the station you want
to listen to before you turn off the player.
To stop play
Press POWER to turn off the power.
22The Timer |
ACEC
