3-261-841-61 (1)
2
A
FM/AM
Compact Disc
Player
Installation/Connections
Instalaci?n/Conexiones
B
AUDIO OUT REAR
CDX-SW200
? 2004 Sony Corporation Printed in Korea
CautionsConnection example (2)
1YThis unit is designed for negative ground 12 V DCNotes (2-B)
operation only.YBe sure to connect the ground lead before
connecting the amplifier.
YDo not get the leads under a screw, or caught in
123YIf you connect an optional power amplifier and
moving parts (e.g. seat railing).
do not use the built-in amplifier, the beep
YBefore making connections, turn the car ignition
sound will be deactivated.
off to avoid short circuits.
YConnect the yellow and red power input leads
only after all other leads have been connected.
� 4YRun all ground leads to a common groundConnection diagram (3)
point.1To a metal surface of the car
YBe sure to insulate any loose unconnected leadsFirst connect the black ground lead, then
with electrical tape for safety.connect the yellow and red power input leads.
45
YThe use of optical instruments with this product2To the power antenna control lead or power
will increase eye hazard.supply lead of antenna booster amplifier
Notes
Notes on the power supply lead (yellow)YIt is not necessary to connect this lead if
there is no power antenna or antenna
YWhen connecting this unit in combination with
� 2booster, or with a manually-operated
other stereo components, the connected car
telescopic antenna.
circuitOs rating must be higher than the sum of
YWhen your car has a built-in FM/AM antenna
each componentOs fuse.in the rear/side glass, see ONotes on the
YWhen no car circuits are rated high enough,control and power supply leads.�
connect the unit directly to the battery.3To AMP REMOTE IN of an optional power
amplifier
This connection is only for amplifiers.
Connecting any other system may damage the
Equipment used in illustrations (not supplied)
Parts Iist (1)unit.
Equipo utilizado en las ilustraciones (no suministrado)4To the +12 V power terminal which is
YThe numbers in the list are keyed to those in the
energized in the accessory position of the
instructions.
ignition key switch
YThe bracket 1 and the protection collar 3 are
Notes
attached to the unit before shipping. BeforeYIf there is no accessory position, connect to
mounting the unit, use the release keys 5 tothe +12 V power (battery) terminal which is
remove the bracket 1 and the protection collar 3energized at all times.
Power amplifierFront speaker
from the unit. For details, see ORemoving theBe sure to connect the black ground lead to
Amplificador de potenciaAltavoces delanteros
protection collar and the bracket (4)� on thea metal surface of the car first.
reverse side of the sheet.YWhen your car has a built-in FM/AM antenna
in the rear/side glass, see ONotes on the
YKeep the release keys 5 for future use as they
control and power supply leads.�
are also necessary if you remove the unit from
5To the +12 V power terminal which is
your car.
energized at all times
Be sure to connect the black ground lead to a
Caution
metal surface of the car first.
Handle the bracket 1 carefully to avoid injuring
Rear speaker
Altavoces traserosyour fingers.
1
Catch
Note
Before installing, make sure that the catches on
both sides of the bracket 1 are bent inwards 2 mm
(3/32 in).
If the catches are straight or bent outwards, the unit
will not be installed securely and may spring out. |
ACEC
