Attaching the front panel
Place the hole A in the front panel onto the
spindle B on the unit as illustrated, then push
Getting Started
the left side in.
Resetting the unitA
Before operating the unit for the first time or
B
after replacing the car battery, you must reset
the unit.
Remove the front panel and press the RESET
button with a pointed object, such as a ball-
point pen.
RESET button
x
Note
Pressing the RESET button will erase the clock
setting and some memorised functions.
Detaching the front panel
You can detach the front panel of this unit to
protect the unit from being stolen.
Notes
1Press (OFF).YBe careful not to attach the front panel upside
down.
YDo not press the front panel too hard against the
2Press (OPEN), then slide the front panelunit when attaching it.
to the right side, and pull out the leftYDo not press too hard or put excessive pressure
side of the front panel.on the display window of the front panel.
YDo not expose the front panel to direct sunlight
or heat sources such as hot air ducts, and do not
leave it in a humid place. Never leave it on the
dashboard of a car parked in direct sunlight or
where there may be a considerable rise in
temperature.
1
Caution alarm
2
If you turn the ignition key switch to the OFF
position without removing the front panel, the
caution alarm will beep for a few seconds.
Notes
If you connect an optional power amplifier
YDo not put anything on the inner surface of the
and do not use the built-in amplifier, the beep
front panel.
YBe sure not to drop the panel when detaching itsound will be deactivated.
from the unit.
YIf you detach the panel while the unit is still
turned on, the power will turn off automatically
to prevent the speakers from being damaged.
YWhen carrying the front panel with you, use the
supplied front panel case.
8 |
ACEC
