Specifications
AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL HARMONIC DISTORTION
23 watts per channel minimum continuous average power into
4 ohms, 4 channels driven from 20 Hz to 20 kHz with no more
than 5% total harmonic distortion.
CD player sectionGeneral
Signal-to-noise ratio90 dBOutputsAudio outputs
Frequency response10 � 20,000 HzPower antenna relay
Wow and flutterBelow measurable limitcontrol lead
Power amplifier control
lead
Tuner section
Tone controlsBass 10 dB at 20 Hz
FMTreble 10 dB at 20 kHz
Tuning range87.5 � 107.9 MHzPower requirements12 V DC car battery
Antenna terminalExternal antenna connector(negative ground)
Intermediate frequency10.7 MHzDimensionsApprox. 178 � 50 � 177 mm
Usable sensitivity11 dBf(7 1/8 � 2 � 7 in.)
Selectivity75 dB at 400 kHz(w/h/d)
Signal-to-noise ratio65 dB (stereo),Mounting dimensionsApprox. 182 � 53 � 161 mm
113
68 dB (mono)(7 /4 � 2 /8 � 6 /8 in.)
Harmonic distortion at 1 kHz(w/h/d)
0.7 % (stereo),MassApprox. 1.2 kg
0.5 % (mono)(2 lb 10 oz)
Separation33 dB at 1 kHzSupplied accessoriesParts for installation and
Frequency response30 � 15,000 Hzconnections (1 set)
Front panel case (1)
AMCard remote commander
Tuning range530 � 1,710 kHz RM-X115
Antenna terminalExternal antenna connectorOptional accessoriesBUS cable (supplied with
Intermediate frequency10.7 MHz/450 kHzan RCA pin cord)
Sensitivity30 V RC-61 (1 m), RC-62 (2m)
Optional equipmentCD changer (10 discs)
CDX-656
Power amplifier sectionCD changer (6 discs)
OutputsSpeaker outputs CDX-T69
(sure seal connectors)MD changer (6 discs)
Speaker impedance4 � 8 ohms MDX-66XLP
Maximum power output 50 W � 4 (at 4 ohms)MG Memory Stick
System-up Player
MGS-X1
Note
This unit cannot be connected to a digital
preamplifier or an equalizer.
Design and specifications are subject to change
without notice.
17 |
ACEC
