Attaching the front panel
Attach part a of the front panel to part b of
Getting Startedthe unit as illustrated and push until it clicks.
Resetting the unit
Before operating the unit for the first time or
after replacing the car battery, you must reseta
the unit.
Remove the front panel and press the resetb
button with a pointed object, such as a ball-
point pen.
Notes
YBe sure not to attach the front panel upside
down.
YDo not press the front panel too hard against the
unit when attaching it.
Reset buttonYDo not press too hard or put excessive pressure
on the display window of the front panel.
NotesYDo not expose the front panel to direct sunlight
YPressing the reset button will erase the clockor heat sources such as hot air ducts, and do not
setting and some memorized functions.leave it in a humid place. Never leave it on the
YWhen you connect the power supply cord to the
unit or reset the unit, wait for about 10 secondsdashboard of a car parked in direct sunlight or
before you insert a disc. If you insert a disc withinwhere there may be a considerable rise in
these 10 seconds, the unit will not be reset, andtemperature.
you will have to press the reset button again.
Caution alarm
If you turn the ignition key switch to the OFF
position without removing the front panel, the
caution alarm will beep for a few seconds.
Detaching the front panelIf you connect an optional power amplifier and
do not use the built-in amplifier, the beep
You can detach the front panel of this unit tosound will be deactivated.
protect the unit from being stolen.
1Press (OFF).
2Press (RELEASE) ,then slide the front
panel a little to the left, and pull it off
towards you.
(OFF)
(RELEASE)
Notes
YBe sure not to drop the panel when detaching it
from the unit.
YIf you detach the panel while the unit is still
turned on, the power will turn off automatically
to prevent the speakers from being damaged.
YWhen carrying the front panel with you, use the
supplied front panel case.5 |
ACEC
