Attaching the front panel
Place the hole A in the front panel onto the
spindle B on the unit as illustrated, then push
Getting Started
the left side in.
Resetting the unit
A
Before operating the unit for the first time or
B
after replacing the car battery, you must reset
the unit.
Remove the front panel and press the reset
button with a pointed object, such as a ball-
point pen.
Reset button
x
Note
Pressing the reset button will erase the clock
setting and some memorized functions such as the
station memo.
Detaching the front panel
You can detach the front panel of this unit to
protect the unit from being stolen.
Notes
YBe careful not to attach the front panel upside
1Press (OFF).down.
YDo not press the front panel too hard against the
unit when attaching it.
2Press (OPEN), then slide the front panelYDo not press too hard or put excessive pressure
to the right side, and pull out the lefton the display window of the front panel.
YDo not expose the front panel to direct sunlightside of the front panel.
or heat sources such as hot air ducts, and do not
leave it in a humid place. Never leave it on the
dashboard of a car parked in direct sunlight or
where there may be a considerable rise in
temperature.
Caution alarm
1
If you turn the ignition key switch to the OFF
2position without removing the front panel, the
caution alarm will beep for a few seconds.
If you connect an optional power amplifier and
Notesdo not use the built-in amplifier, the beep
YDo not put anything on the inner surface of thesound will be deactivated.
front panel.
YBe sure not to drop the panel when detaching it
from the unit.
YIf you detach the panel while the unit is still
turned on, the power will turn off automatically
to prevent the speakers from being damaged.
YWhen carrying the front panel with you, use the
supplied front panel case.
7 |
ACEC
