Note
You cannot play 8cm (3in.) CDs.
Changing the transmitting
If the disc magazine does not lock properlyfrequency
Take out the disc magazine, press Z, and re-
insert it.Because this unit processes CD playback
sound through an FM tuner, there may be
Use the unit with the door closedinterference noise during CD playback. In such
completelya case, change the frequency of the modulated
Otherwise, foreign matter may enter the unitRF signal transmitted from the unit. The initial
and contaminate the lenses inside the CDsetting is 88.3 MHz.
changer.
1Press (SHUF/REP) for two seconds until
Notes on the disc magazinefrequency appears.
YDo not leave the disc magazine in locations
with high temperature and high humidity,2Press or repeatedly to
such as on a car dashboard or in the rear
select the frequency.
window where the disc magazine will beEach time you press or ,
subject to direct sunlight.
YDo not place more than one disc at a timethe frequency changes as follows:
onto a tray, otherwise the CD changer and :
the discs may be damaged.88.3 MHz t 89.9 MHz t 89.7 MHz t
YDo not drop the disc magazine or subject it to89.5 MHz t 89.3 MHz t 89.1 MHz t
a violent shock.88.9 MHz t 88.7 MHz t 88.5 MHz t
88.3 MHz
When the tray comes out :
88.3 MHz t 88.5 MHz t 88.7 MHz t
Normally, the trays will not come out of the
88.9 MHz t 89.1 MHz t 89.3 MHz t
disc magazine. However, if they are pulled out89.5 MHz t 89.7 MHz t 89.9 MHz t
of the disc magazine, it is easy to re-insert
them.88.3 MHz
3Press (SHUF/REP) for two seconds.
Notes
YWhen you change the transmitting frequency on
the unit, be sure to tune your FM tuner to the
newly selected one.
YPress u on the wired remote before changing
the frequency if the power to the unit is turned
off.
With the cut-away portion of the tray facing you,
insert the right corner of the tray in the slot, then
push in the left corner until it clicks.
Note
Do not insert the tray upside down or in the
wrong direction.
5 |
ACEC
