Getting StartedGetting Started
UnpackingHooking Up the System
Check that you received the following items:
Y Audio cord (1)Overview
Y Remote commander (remote) (1)
This section describes how to hook up the CD player to
Y Size AA (R6) batteries (2)
an amplifier. Be sure to turn off the power of each
Y CD booklet holders (2) and label (1)
component before making the connections.
How to use the CD booklet holderCOMMANDDIGITAL OUT
The CD booklet holder helps you locate the disc easily.CONTROL A1MODE(OPTICAL)
After you have inserted discs into the player, you can putCD player
the CD booklet (which comes with a CD) into the
supplied holder. Put two CD booklets facing back to back
into a pocket. Stick the number label on each pocket,
matching the number of the disc slot where you have
inserted the disc. You can put up to 200 CD booklets into
the holders.
Inserting batteries into the remoteTo an AC outlet
You can control the player using the supplied remote.To line output (R)To line output (L)
Insert two size AA (R6) batteries by matching the +
and � on the batteries to the diagram inside the battery
compartment.
Insert the negative (�) end first, then push in and down
until the positive (+) end clicks into position.
When using the remote, point it at the remote sensor g
on the player.To audio input
Amplifier
: Signal flowTo an AC outlet
What cords will I need?
Audio cord (1) (supplied)
When to replace batteries
With normal use, the batteries should last for about six
months. When the remote no longer operates the player,
WhiteWhite
replace all the batteries with new ones.
(L)(L)
RedRed
(R)(R)
Notes
Y Do not leave the remote near an extremely hot or humid
place.
Y Do not drop any foreign object into the remote casing,
particularly when replacing the batteries.
Y Do not expose the remote sensor to direct sunlight or
lighting apparatuses. Doing so may cause a malfunction.
Y If you do not use the remote for an extended period of time,
remove the batteries to avoid possible damage from battery
leakage and corrosion.
4 |