Playing CDs
Making digital hookups
If you have a digital component such as aLoading a CD
digital amplifier, D/A converter, DAT, or MD,
connect the component via the DIGITAL OUT
1Turn on the amplifier and select the CDGetting Started
(OPTICAL) connector using the optical cableplayer position so that you can listen to
(not supplied). Take off the cap and plug in thethe sound from this player.
optical cable.
2Press POWER to turn on the player.
Note that you cannot use the following
functions when making this connection:3Press AOPEN/CLOSE.
Y Fading In or Out (see page 12)The disc compartment slides out.
Y Adjusting the output level using the4Place a disc on the disc tray with the
ANALOG OUT LEVEL +/� buttons on thelabel side up.
remote
POC-15
Playing CDs
Optical cable (not supplied)
CD playerDigital component
DIGITAL
DIGITALDisc number
INPUT
OUTWhen you play a CD single,
OPTICALOPTICAL
place it on the inner circle
of the tray.
5To place other discs, press DISC SKIP
and place the discs in the order you
want to play.
NoteEach time you press the button, the disc tray
When you connect via the DIGITAL OUTturns and you can place the discs in the
(OPTICAL) connector, noise may occur when youempty disc compartments. The player plays
play CD software other than music, such as a CD-
the disc in front of you first.
ROM.
6Press AOPEN/CLOSE to close the disc
Transporting the playercompartment.
Before transporting the player, follow the
procedure below to return the internal
mechanisms back to their original position.
1Remove all the discs from the disc tray.
2Press A OPEN/CLOSE to close the
disc tray.
Ono dISC� appears in the display.
3Wait for 10 seconds, then press
POWER to turn off the player.
7 |
ACEC
