l-l-4. Adjusting Remote Control Unitl Changing the address
The adjusting remote control unit is used for rewriting theThe address will increase when the FF ( )) ) button is
adjustment data written in the non-volatile memory necessary forpressed, and decrease when the REW ( 44 ) button is pressed.
performing the adjustments.There are altogether 256 addresses, from 00 to FF.
The adjusting remote control unit used the remote control signall Changing the data (Data setting)
line (LANC) to correspond mutually with the camera microThe data will increase when the PLAY ( b ) button is pressed,
processor. The page, address and the up/down command of the dataand decrease when the STOP ( n ) button is pressed
can be transmitted from the remote control unit to the camera microThere are altogether 256 data, from 00 to FF.
processor. On the other hand, the page, address,?and data can alsol Writing the adjustment data
be transmitted the other way round.It is necessary to press the PAUSE button to write the
adjustment data (F page) in the non-volatile memory.
1. Using the adjusting remote control unit(The new adjustment data will not be recorded in the
1) Connect the extension cable (J-6082-084-A) and the adjustmentnon-volatile memory if this operation is not performed.)
remote control, to the remote terminal (K-173 board CNlOl).4) Select page : 6, address : 00, and adjust the data to 01. This
However make sure the extension cable switch is OFF (open).releases the write protect of page F, and the camera section (F
2) Adjust the HOLD switch if the adjusting remote control unit topage address : 01 to DF) can be adjusted.
HOLD (SERVICE position).5) After completing all adjustments, turn off the main power (6V)
If it has been properly connected, the LCD on the adjustingonce. This can release the adjustment mode (other than page F).
remote control unit will show the display in Fig. 6-l-4.
2. Precautions upon using the adjusting remote control
unit
The correct adjustment data may be erased at times, due to
operation errors of the adjusting remote control unit. To prevent
this from occurring, it is recommended that all adjustment data be
recorded in the memory before beginning adjustments, and the new
adjustment data be recorded in the memory after each adjustment.
1-J W +J
Pagedata Address
Fig. 6-l-4.
3) Operate the adjusting remote control unit as follows.
l Changing the page
The page will increase when the EDIT SEARCH + button is
pressed. It will decrease when the EDIT SEARCH - button is
pressed. There are altogether 16 pages, from 0 to F.
Hexadecimal
(0123456789ABCDEFI
notation
notation
conversion10 1 2 3 4 5 6 7 8 9 1011 121314151
valueII
Table 6-1-1.
6-4 |
ACEC
