GB
When the refrigerator
is not in use
In case the appliance will not be used for a long time
follow these steps:
Break the circuit of the appliance.
Remove foods from the refrigerator.
Defrost and clean it as written before.
Leave the door open to avoid a build up of air inside.
Trouble shooting
During operation of the appliance some smaller but
annoying trouble can often occur, which does not
require calling a technician out. In the following chart
information is given about them to avoid unnecessary
charges on service.
We draw your attention that operation of appliance goes
with certain sounds (compressor- and circulating
sound). This is not trouble, but means normal
operation.
We draw it to your attention again that the
appliance operates discontinuously, so the
stopping of compressor does not mean being no-
current. That is why you must not touch the electrical
parts of the appliance before breaking the circuit.
ProblemPossible causeSolution
The appliance does notThermostatic control is set too low.Set higher position.
cool sufficientlyBefore freezing the appliance was not pre-cooledPre-cool the appliance for enough time.
sufficiently.
Large-sized food was put in.Cut up food.
Too many foods to be frozen were put in.Put fewer foods to be cooled.
Warm foods were put in.Put foods max. at room temperature.
Door is not shut properly.Check if the door is shut.
The appliance cools tooThe thermostatic control is set too high.Set lower position.
hard
The appliance does notPlug is not connected to the mains socketCheck if the connection is proper.
cool at allproperly.
There is no voltage in the mains socket.Check if there is voltage.
Thermostatic control is in ?STOP? position.Check setting of thermostatic control.
The appliance is noisyThe appliance is not supported properly.Check if the appliance stands stable.
Inasmuch as the advice does not lead to result, call the nearest brand-mark service.
47 |