CleaningWhat do I do, if ...
As required, wipe the housing and the paper fil-... it is difficult to push the nozzle
ter compartment with a damp cloth. Do not use
any scourers or any solvents. Occasionally vac-Reduce the power setting on the appliance. This
uum the floor nozzle and brush-heads with thewill not reduce cleaning efficiency.
crevice nozzle.... the motor thermal cut-out is activated
If the motor is overloaded, e.g. due to a full fil-
ter bag or blocked accessory, the thermal cut-
out shuts down the motor. In this case, switch
Paper filteroff the appliance, unplug from the mains, and
Progress P58leave the motor to cool down.
Check paper filter bag, suction tube and suction
hose; remove any blockage.
Carrying and StorageThe appliance can be switched on again after
approximately 30 minutes.
... the fuse has blown
The fuse may blow if you use other electrical
appliances with high power consumption on the
same electric circuit at the same time as the
vacuum cleaner is in use.
This can be avoided if you set the electronic
power adjuster to the lowest power level and
To make the appliance easier to store and carry,then select a higher level after switching the
slide the floor nozzle into the tool rail.
appliance on.
Your vacuum cleaner can be fitted with a gentle
start-up control which reduces the starting cur-
rent to the motor and therefore prevents the
electric circuit cut-out being triggered under
normal conditions. It is possible that there will
be a delay of about 4 seconds in the appliance
starting up on the lowest power level.
Parking System
For storing the suction pipe and nozzle during
short pauses in vacuuming. The bracket on the
nozzle is slid into the parking rail on the appli-
ance.
? the paper filter is damaged at some stage
and the HEPA filter is dirtied
Remove the HEPA filter, clean (tap out) and
replace.
Insert new paper filter.
13 |
ACEC
