INSTALLATION
If this refrigerator featuring magnetic door seals is Electrical connection
to replace an older appliance having a spring lock
(latch) on the door or lid, make sure that the spring Before plugging in, ensure that the voltage and
lock is unusable before you discard the old frequency shown on the serial number plate
appliance. This will prevent it from becoming a correspond to your domestic power supply. Voltage
death-trap for a child.can vary by ?6% of the rated voltage. For operation
with different voltages, a suitably sized auto-
transformer must be used.
Positioning
The appliance must be earthed.
The appliance should be installed well away from The power supply cable plug is provided with a
sources of heat such as radiators, boilers, direct contact for this purpose. If the domestic power
sunlight etc.; best performance is obtained with supply socket is not earthed, connect the appliance
ambient temperature between +10°C and +32°C.to a separate earth in compliance with current
For building-in and door reversibility refer to the regulations, consulting a specialist technician.
relevant instructions.The Manufacturer declines all responsibility if the above
safety precautions are not observed.
This appliance complies with EEC directive
number 87/308 of 2/6/87 relative to radio
interference suppression.
This appliance complies with the following
E.E.C. Directives:
- 73/23 EEC of 19.2.73 (Low Voltage Directive) and
subsequent modiŢcations;
- 89/336 EEC of 3.5.89 (Electromagnetic
Compatibility Directive) and subsequent
modiŢcations.
Cleaning the inside
Before using, clean all inside parts with warm water
and neutral soap to remove the typical new smell.
Dry thoroughly. Do not use abrasive detergent or
powders as these can damage the Ţnish.
11 |