Connecting antennas
To the use the tuner of DTR-7.1, it is necessary to prepare the
Connecting the included antennas
supplied FM and AM antennas.
Y Adjustment and placement of the FM and AM antennas forConnecting the FM indoor antenna:
better reception must be done while listening to a station
The FM indoor antenna is for indoor use only. During use, extend
broadcast.
the antenna and move it in various directions until the clearest
Y If better reception cannot be obtained, then placement of ansignal is received. Fix it with push pins or similar implements in
outside antenna is recommended.the position that will cause the least amount of distortion.
If the reception is not very clear with the attached FM indoor
antenna, the use of an outdoor antenna is recommended.
Assembling the AM loop antenna
Connecting the AM loop antenna:
Assemble the loop antenna as shown in the illustration.The AM loop antenna is for indoor use only. Set it in the direction
Y Refer to the next page for details on connecting the AM loopand position where you receive the clearest sound. Put it as far
antenna.away as possible from the DTR-7.1, televisions, speaker cables,
and power cords.
When reception is not satisfactory with the attached AM loop
antenna alone, connection of an outdoor antenna is recommended.
FM antenna
Insert into the hole.
Connecting the AM antenna cable
Strip away the insulation
from the end of the cable,
1. Press down the lever.
then fully insert the
stripped end of the cable.
2. Insert the wire into the hole.
3. Release the lever.
ANTENNAAMFM
3REMOTE 1275
DIGITALCONTROL
OUTPUT
(OPTICAL)12 V
PRETRIGGER
ROUTLBAZONE 2 MAIN
1FRONTIR IN
DIGITAL
INPUTRLVIDEOS VIDEO
(OPTICAL)SURR
(Indoor) AM loop antenna
Hint:
Either of the split ends of the AM antenna can be connected to
either terminal. Unlike speaker cabling, there is no polarity for
AM broadcast signals.
22 |
ACEC
