1
2
85u
EngTo Assemble Bagger
NOTE: For ease of assembly, you may wish to obtain the
assistance of another person when putting the bagger to-
4gether.
1. Front bagger tube
Holes in front bagger tube are at an angle. Place front
3
2. Lower bagger tubebagger tube against lower bagger tube and check for
proper hole alignment before assembling bolts.
3. 1/4 x 50,8mm Carriage
BoltsAssemble front and lower bagger tubes using four (4)
1/4 x 50,8mm carriage bolts and lock nuts supplied.
4. 1/4 Lock nut
Tighten securely.
5Slide front and lower bagger tube assembly into the
bagger assemby.
Assemble front and upper bagger tubes using four (4)
31/4 x 50,8mm carraige bolts and lock nuts supplied.
Tighten securely.
Slip all the vinyl bindings over the bagger tubes
Slide the bagger dump handle through the hole in the
2
bagger top, install the clevis pin and secure with retainer
spring.
6
1. Front bagger tubeNOTE: For future use, the clevis pin may be removed in order
7to use the handle to clear the chute in the event it has become
2. 1/4 x 50,8mm Carriage
clogged.
Bolts
3. 1/4 Lock nut
Bagger adjustment
1
4. Vinyl Binding
For proper bag function and appearance, it may be neces-
5. Dump handle tubesary to adjust the bagger assembly. There should be 6mm
4(1/4")-9mm (3/8") gap between the bagger top and fender
6. Clevis pin
and the bagger top surface should be even with the top
7. Retainer springsurface of the fender. To adjust bagger position:
6MM (1/4") - 9MM (3/8")
Horizontal adjustment
1
Slightly loosen the nuts securing the bagger RH and LH
2horizontal adjustment brackets. Loosen only enough so
the brackets keep their position, but allow them to be
moved.
Move the brackets the amount forward or backward you
wish the bag assembly to move. Retighten the nuts
securely.
3
Vertical adjustment
Slightly loosen the nuts securing the vertical adjustment
brackets. Loosen only enough so the brackets keep their
1. Top Surfaces Evenposition, but allow them to be moved.
2. Horizontal Adjustment BracketMove the brackets the amount up or down you wish the
bag assembly to move. Retighten the nuts securely.
3. Vertical Adjustment Bracket
Reinstall the bagger assembly and check the bagger to
fender fit. If necessary, repeat the procedure until proper
1fit is attained.
2
To convert to bagging, mulching or discharge
See "Section 5" of this manual.
A
To assemble and install mulcher plug
3
Remove spring retainer and pin from handle.
1. HandleInsert plug into handle. Make sure that the letter "A" on
A
both the plug and handle are on the same side and that
2. Retainer Spring
they can both be seen from the top when laying on the
3. Pinground.
4. PlugSecure with pin and retainer spring provided. For instal-
4lation see "To Convert Mower" in Section 5 of this manual.
25 |
ACEC
