MAINTENANCE
Needle bearing lubricationCooling system
The clutch drum is Ţtted with one of the following drive To keep the working temperature as low as possible the
sprockets:machine is equipped with a cooling system.
? A Spur sprocket (the chain sprocket is welded on the The cooling system consists of:
drum)1 Air intake on the starter.
? B Rim sprocket (replaceable)2 Air guide plate.
3 Fins on the �ywheel.
4 Cooling Ţns on the cylinder.
5 Cylinder cover (directs cold air over the cylinder).
Both versions have a needle bearing on the drive shaft, which
has to be greased regularly (once a week).
CAUTION! Use a high-quality bearing grease or engine oil.
Clean the cooling system with a brush once a week, more
often in demanding conditions. A dirty or blocked cooling
system results in the machine overheating which causes
damage to the piston and cylinder.
?Air Injection? centrifugal cleaning
Adjustment of the oil pumpCentrifugal cleaning means the following: All air to the
carburettor passes through the starter. Dirt and dust is
centrifuged out by the cooling fan.
The oil pump is adjustable. Adjustments are made by turning
the screw using a screwdriver or combination spanner. The
machine is supplied from the factory set to 1 turn open.
Turning the screw clockwise will reduce the oil �ow and
turning the screw anti-clockwise will increase the oil �ow.
IMPORTANT! In order to maintain operation of the centrifugal
cleaning system it must be regularly maintained.
? Clean the air intake to the starter, the Ţns on the �ywheel,
the space around the �ywheel, inlet pipe and carburettor
compartment.
Heated handles
WARNING! The engine must not be running
(385XPG)when making adjustments.
On models with the model code XPG/G both the front handle !
bar and the rear handle are equipped with electrical heating
Recommended settings:
coils. These are supplied with electricity from a generator built
into the chain saw.Bar -15":1 turn from the closed position.
Bar 15" -18":2 turns from the closed position.
Bar 18" -24":3 turns from the closed position.
Bar 24" -:4 turns from the closed position.
These recommendations apply to Husqvarna?s chain oil, for
other chain oils increase the oil �ow by one step.
34 - English |