Adattamento ai diversi tipi di gas
Sostituzione degli ugelli
1. Togliete le griglie.
2. Togliete i cappellotti e gli spartifiamma dai bruciatori.
3. Con una chiave a tubo da 7 svitate e togliete (Fig. 9)
gli ugelli, sostituendoli con quelli corrispondenti al tipo
di gas di funzionamento (vedi tabella 'Caratteristiche
dei bruciatori' a pag. 6).
4. Rimontate le parti eseguendo all?inverso le operazioni
descritte.
5. Sostituite quindi la targhetta taratura (posizionata
vicino all?attacco della rete gas) con quella corri-
spondente al nuovo tipo di gas. Quest?ultima si
trova nel sacchetto degli iniettori a corredo.
Qualora la pressione del gas impiegato sia diversa (o
variabile) rispetto a quella prevista, e necessario in-FO 0392
stallare sulla tubazione di ingresso, un appropriato re-Fig. 9
golatore di pressione per gas canalizzati (NON GPL)
conformi alla norma UNI-CIG 7430.
L?utilizzo di regolatori di pressione per gas liquidi
(GPL) e consentito purche questi siano conformi alla
norma UNI-CIG 7432.
Regolazione del minimo
Per regolare il minimo, procedete come segue.
1. Accendete il bruciatore come precedentemente
descritto.
2. Portate il rubinetto sulla posizione di minima fiam-
ma.
3. Estraete le manopole.
4. Agite sullo spillo by-pass indicato nella figura 10.
? Se operate una trasformazione da gas metano a
gas GPL, avvitate a fondo in senso orario lo spillo
by-pass.
? Il risultato dovra essere una piccola fiamma omo-
genea e regolare su tutta la corona del bruciato
re.
5. Verificate infine che, ruotando rapidamente il rubinetto
dalla posizione di massimo a quella di minimo, non si
abbiano spegnimenti del bruciatore.
Le operazioni di adattamento sopra descritte si possono
effettuare agevolmente, qualunque sia il posizionamento
o il fissaggio del piano di cottura al mobile da cucina.
Fig. 10
Spillo by-pass
per la regolazione del minimo
11 |