Installation Instructions
Safety instructions
The laws, ordinances, directives and standards in
force in the country of use are to be followed (safety
regulations, proper recycling in accordance with the
regulations, etc.)
Installation may only be carried out by a qualified
electrician.
The minimum distances to other appliances and
units are to be observed.
Drawers may only be installed under the appli-
ance with a protective floor.
The cut surfaces of the worktop are to be protected
against moisture using a suitable sealant.
The sealant seals the appliance to the work top with
no gap.
Avoid installing the appliance next to doors and un-
der windows. Otherwise hot cookware may be
knocked off the rings when doors and windows are
opened.
1Warning!
Risk of injury from electrical current.
The combination appliance is live.
Observe electrical safety rules.
Ensure anti-shock protection through correct in-
stallation by a qualified electrician.
Rated voltage of the combined appliances must
match.
1Important!
Risk of injury from electrical current.
Loose and inappropriate plug and socket con-
nections can lead to overheating of the plug.
Fit plug and socket connections together properly.
A device must be provided in the electrical installa-
tion which allows the appliance to be disconnected
from the mains at all poles with a contact opening
width of at least 3 mm.
Suitable isolation devices include line protecting cut-
outs, fuses (screw type fuses are to be removed from
the holder), earth leakage trips and contactors.
Sticking on the seal
Clean the worktop around the cut-out area.
Stick the single-sided adhesive sealing tape pro-
vided on the underside of the hob around the out-
side edge ensuring that it is not stretched. The two
ends of the tape should join in the middle of one
side. After trimming the tape (allow it to overlap by
2-3 mm), press the two ends together.
10 |
ACEC
