Instrucciónes para el instalador
Instalación
Es necesario que todas las operaciones relativas a laEn la bolsa de accesorios, adjuntamos un codo con la
instalación, regulación y adaptación al tipo de gas quejunta para efectuar la unión a la encimera (figura 5). El
vaya a utilizarse, sean realizadas por personal cualificado,terminal del tubo de gas de la encimera es roscado G 1/
según las normas en vigor.2.
(Real Decreto 1853/1993 ?Reglamento deImportante
instalaciones de gas en locales destinados a usosPara un seguro funcionamiento, un menor consumo y una
domésticos colectivos o comerciales? y Real Decre-mayor duración del aparato, asegúrese de que la presión
to 494/1988 ?Reglamento de Aparatos que utilizande alimentación respeta los valores indicados en la tabla
gas como combustible?)de caracterÃsticas de los quemadores.
ImportanteUn vez terminada la instalación se debe comprobar
Cualquier intervención debe efectuarse con el aparatola perfecta estanquidad de todos los tubos,
desconectado eléctricamente y con la llave del gasracores, uniones, etc., utilizando para ello una
cerrada. Cuando sea necesario que esté conectado sesolución jabonosa. JAMAS SE DEBEN UTILIZAR
deben observar las máximas precauciones.LLAMAS.
Conexión del gas
En el caso de instalación con tubo metálico flexible,
asegúrese de que el tubo no está en contacto con partes
mobiles o aplastado. El mismo control debe ser efectuado
también en el caso de acoplamiento horno con encimera.
Las encimeras están preparadas para el tipo de gas,
presión, voltaje, etc., que figura en la placa de
caracterÃsticas. Compruebe que coinciden con los que
dispone en su domicilio.
FO 0264
A) Tubo de alimentaciónFig. 5
B) Junta
C) Codo orientable
7 |