Installation
IMPORTANT
This hob must be installed by qualified
personnel to the relevant British Standards.
Any gas installation must be carried out by
a registered CORGI installer.
The manufacturer will not accept liability,
should the above instructions or any of the
other safety instructions incorporated in
this book be ignored.
On the end of the shaft, which includes the GJ 1/2"
threaded elbow, adjustment is fixed so that the washer
is fitted between the components as shown in the
diagram. Screw the parts together without using
excessive force.
FO 0814
Gas Connection
Connection to the gas supply should be with either
rigid or semi-rigid pipe, i.e. steel or copper.
FO 0264
The connection should be suitable for connecting to
RC 1/2 (1/2 BSP male thread).A) End of shaft with nut
When the final connection has been made, it isB) Washer
essential that a thorough leak test is carried out on theC) Elbow
hob and installation.
Ensure that the main connection pipe does not exert
any strain on the hob.
It is important to install the elbow correctly,
Rectangular cut-out size for hob
with the shoulder on the end of the thread,
fitted to the hob connecting pipe.
Failure to ensure the correct assembly will
580
cause leakage of gas.500
Cut Out Size
The dimensions of the cut-out are given in the
diagram.
550
470
55 min.
FO 2109
14 |