InstallazioneCaractéristiques techniques
Mod eleEFC 939.1EFC 639.1
Dimensionshauteur590 - 910 mm590 - 910 mm
largeur898 mm598 mm
profondeur490 mm490 mm
Eclairage2 x 20 W2 x 20 W
Filtre a graisse2 pces1 pce
Puissance nominale totale200 W200 W
Nous nous réservons d?apporter toute modification en termes constructifs et chrévélera omatiques qui se r
nécessaire au vu de l?évolution technologique.
Accessoires
Filtre a charbon actif 942 120 182
Installation
D éballage
Vérifiez que la hotte n?est pas endommagée.
Signalez immédiatement tout dégât du au transport
a la personne compétente et tout défaut ou manque
Min
au fabricant.Min
75 cm
60 cm
Ne laissez pas traîner le matériel d?emballage pour
éviter que les enfants ne jouent avec lui.
Montage
La hotte aspirante doit etre montée au mur. Une
Fig. 6
fois installée, elle doit etre a au moins 60 cm des
corps de chaufélectriques et 75 cm des brfe uleurs
a gaz et mixtes (fig. 3).
Raccordement électriqueLes dispositifs de protection adéquats sont, par ex,
des commutateurs, des fusibles (les fusibles a vis
La hotte est munie d?un cordon électrique a fiche
doivent etre extraits de la douille), des disjoncteurs
moulée, avec mise a terre, pour raccordement a
FI et des disjoncteurs ayant une course d?ouvertu-
une prise murale de 230 V.
re de contact supérieure a 3 mm.
La sortie doit etre pré-montée de telle maniere que
Notre responsabilité ne peut etre engagée pour les
le cordon soit invisible une fois la hottedéfauts résultants du non respect des instructions
complétement installée.précédemment mentionnées.
Le cordon mesure 1,25 m.La pose de la prise de courant directement au-
dessus de la hotte aspirante possede deux
Consignes de sécurité pour l?électricien
avantages :
Avant de brancher l?appareil, vérifier que la
1.La prise de courant est cachée.
tension indiquée sur la plaque signalétique
2.En cas de besoin, il sera tres facile de
correspond a celle du secteur. Si l?appareil est
mettre l?appareil hors tension en tirant sur la fiche
muni d?une fiche de courant, il pourra etre branché
de courant.
sur n?importe quelle prise de courant installée
Branchement
conformément aux normes et facile d?acces.
220-240 V - avec câble prémonté avec prise de
Si un branchement permanent est nécessaire, la
courant (branchement permanent uniquement par
hotte devra etre branchée par un électricien
un électricien agréé).
travaillant pour une entreprise d?électricité agréée.
Côté installation, il faudra prévoir un dispositif de
protection sur tous les pôles avec une course
d?ouverture de contact d?au moins 3 mm.
17 |