125981280.qxp 2005-03-17 13:22 Page 9
Use
The control panel
ENGLISH
1 Programme/Time selector dialyou wish to switch the buzzer off. The corresponding
light illuminates.
Allows you to select electronically controlled or time
controlled drying.
6 Start button ?START?
Turn the dial to the required programme or time.Press this button for about 2 seconds to start the
Electronically controlled dryingdryer after having selected the programme.
(automatic)If the door is opened while the programme is
The appliance runs these programmes with the helprunning, this button must be pressed again after
of probes which detect the degree of dampness ofclosing the door in order to restart the programme
the laundry.from the point at which it was interrupted.
Simply select the programme according to the typeThis button must also be pressed after a power cut.
of laundry and degree of drying required.In both cases light ?TROCKNEN? or ?ABK�HLEN?
(depending on the phase in progress) flashes to remind
Time controlled dryingyou that the start button needs to be pressed again.
Can be used to finish off drying if necessary.
Select the 60 minute programme for cottons or the7 Programme phase indicator lights
30 minute programme for synthetics .
These lights indicate the various phases of the
To cancel a programme which is running, turn theprogramme as they are being performed.
programme selector dial to ?RESET?.
At the end of drying, turn the selector dial to?Drying? light ?TROCKNEN?
?RESET? before removing the laundryThis light indicates that the appliance is in the drying phase.
2 ON/OFF button ?EIN/AUS??Cooling? light ?ABK�HLEN?
This light indicates that the appliance is in the
This button is used to switch the dryer on. At the end
of the programme, release this button by pressing itcooling phase. At the end of drying, there is a 10
again to switch the dryer off.minute cooling phase to cool the laundry.
If light ?TROCKNEN? or ?ABK�HLEN? is flashing,
3 Mains-ON lightthis means that the Start button needs to be pressed
again for the programme to resume.
Comes on when the appliance is switched on
(EIN/AUS button pressed down) and goes out when?End of programme? light ?ENDE?
this button is released.This light flashes at the end of the cooling phase and
during the anti-creasing phase.
4 Low temperature button ?SCHON?
?Anti-creasing phase? light ?KNITTERSCHUTZ?
Pressing this button allows drying to be performed at
a lower temperature, for delicate items. This light flashes alternately with the light ?ENDE? at
the end of the drying phase (after cooling) and during
The corresponding pilot light comes on.
the anti-creasing phase.
5 Buzzer OFF button ?SIGNAL AUS?If only light ?ENDE? flashes, this means that the anti-
creasing phase has finished.
A buzzer sounds during the anti-creasing phase.
.
Press this button when selecting the programme if
9 |