Cuidado normal de la secadora de tambor
Filtros
APara que la secadora de tambor funcione correctamente, es
preciso limpiar los filtros antes o despuŽs de cada secado de carga.
Para ello:
1.Abra la puerta.
2.Abra el filtro grueso hacia arriba (Fig. A).
3.Elimine con un cepillo las pelusas del filtro de pelusas
(Fig. B), situado bajo el filtro grueso. En ocasiones puede
ser necesario extraer el filtro de pelusas para limpiarlo por
Bambos lados. Aseg�rese de volver a colocarlo correctamente
despuŽs de limpiarlo, antes de cerrar el filtro grueso.
No ponga nunca en marcha la secadora si el filtro de
pelusas no est? limpio ni bien colocado. No utilice la
secadora si el filtro de pelusas est? da-ado (ello podr?a
originar un recalentamiento).
C
Condensador
En todos los modelos de secadora de tambor el aire que circula
por el interior recoge las pelusas. Por consiguiente, Žstas se
acumulan en el condensador y hay que limpiarlo cada cierto
tiempo.
DPara ello:
1.Abra la puerta y abra el filtro grueso hacia arriba.
2.Extraiga el filtro de pelusas y vuelva a cerrar el filtro grueso.
3.Agarre los salientes de la parte superior del condensador
y apriŽtelo contra la puerta con los pulgares (Fig. C y D).
De esta forma el condensador se soltar?, con lo que podr?
desplazarlo hacia arriba o hacia abajo. Tenga cuidado de
no da-ar las piezas sensibles de aluminio.
4.P?ngalo hacia abajo y l?mpielo por ambos lados con unE
aspirador. Extraiga el tap?n de desagźe rojo situado en el
extremo inferior del condensador (Fig. E). Coloque el
condensador en posici?n horizontal y llŽnelo de agua a
travŽs de la abertura del filtro. Deje que se empape bien
de agua durante cinco minutos y, a continuaci?n, l?mpielo
con agua caliente (con una ducha de mano, por ejemplo)
Fpor ambos lados (Fig. F). Posteriormente, sŽquelo bien.
No olvide volver a colocar el tap?n de desagźe rojo (Fig. G ).
5.Vuelva a colocar el condensador en la secadora.
Compruebe que la base queda a la misma altura que las
ranuras en la cavidad del condensador, dentro de la
puerta de la secadora. Col?quelo en su lugar con cuidado
Ghasta que note que queda bien situado (se escuchar? un
suave Oclic�). Vuelva a colocar los filtros de pelusas y
cierre el filtro grueso.
- 12 - |