INTRODUCTION
WARNING: THIS APPLIANCE MUST BE EARTHED
RATING PLATEThe cable must be routed away from potentially hot
areas marked by X in the diagram below.
This is situated on the front frame of the appliance
and can be seen upon opening the door. Alternatively
the rating plate may also be found on the back or top
of some models (where applicable).
The appliance must be protected by a suitably rated
fuse or circuit breaker. The rating of the appliance is
given on the rating plate.
Do not remove the rating plate from the appliance
as this may invalidate the guarantee.
INSTALLATION
To move the appliance, open the fan oven door, and
lift the appliance by holding inside the top of the
If your appliance has been damaged in transit,
compartment.
contact your supplier immediately. DO NOT attempt
to install it.
Your appliance left the factory fully packaged to
protect it from damage. If it is delivered without
packaging and damage has occurred, the
manufacturer cannot accept responsibility. Contact
your supplier for advice.
Once the packaging has been removed the appliance
should only be moved by hand. DO NOT use a sack
barrow or any other aid to lift the appliance as
damage may occur.
This is a type Y appliance which means it is free-
standing and can be fitted with cabinets on one or
Connection to the electricity supply must be carried
both sides. It may also be fitted in a corner setting.
out by a qualified electrician/competent person.
Ensure that the appliance is standing level.
The electrical connection should be made using a
Side walls which are above hob level should be
double pole isolating switch (cooker socket) with at
protected by heat resistant non-combustible material
least 3mm contact separation in all poles. The cable
and MUST NOT be nearer than 40mm to the hob
must have conductors of sufficiently high cross-
side.
sectional area to prevent overheating and
deterioration.A nominal air gap of 2mm all around the appliance is
required to enable the appliance to be moved into
The recommended cross-section area is six squareposition.
2
millimetres (6.00mm).
Two spacers have been incorporated into the back of
the appliance to ensure hotplate level. Tiles or other
forms of deep wall covering should not obscure this
gap.
Air gap
7 |