8. Attach the IDE cable10. Connect the audio cable.
If you have a sound card, you can attach the audio
cable to the audio out connectors.
DIGITAL
AUDIO ANALOGCABLE SELECT
AUDIOSLAVE
0 0MASTER
R G G LCSM
SLA39HOST INTERFACE
40
DIGITA
1POWERAULDIO ANALOGAUDCABLE SELEC
2+5 G G +12IOSLAV0E 0R G G LMASTET
CSMR
SLA394HOST INTE
0RFACE
1POWER
2+5 G G
+12
Pin 1
Attach the EIDE cable so that the red line that signifies
Pin 1 of the cable is aligned with Pin 1 on the drive.
Although the cables that Sony includes with the unit
are keyed so that they may only be installed properly,11. Power up system and Install the CD-Recording
other cables may not be keyed the same. If you usesoftware that came with your drive.
your existing cable, please be sure to align it properly.
The red line side of the cable goes to the set of pins12. Restart System.
closest to the power connector on the drive.
If there are any difficulties in completing the operations
9. Attach the DC power cable.outlined in this manual, please see the troubleshooting
Plug your standard power connection to the drive.guide in Chapter 4. You may also contact the Sony
Technical Support Center.
DIGITAL
AUDIO ANALOGCABLE SELECT
AUDIOSLAVE
0 0R G G LCSMMASTER
SLA39HOST INTERFACE
40
1POWER
2+5 G G +12
22CD-RW Recorder UserOs GuideCD-RW Recorder UserOs Guide23 |
ACEC
