Rear Panel
The rear panel of the Control X has one 5 pin DIN jack used to connect the
Control X to the GENETXa processor with the supplied 5 pin DIN cable.
Connections
Connecting the Control X to your GENETXa Processor is very easy. Just
follow these simple steps when connecting the Control X:
1. Begin with the power to your GENETXa Processor turned off.
2. Using the supplied 5-pin DIN cable, connect from the output jack located
on the rear panel of the Control X to the MIDI/Foot Controller jack on the
back of your GENETXa Processor.
3. Make sure the MIDI/Foot Controller switch on the GENETXa processor is
set to the Foot Controller option and NOT to MIDI.
4. Power up the GENETXa Processor.
When the display returns to the current program number, the Control X is
ready to use. If the Display reads Pf, or your Expression Pedal fails to
function, see the calibration procedure in this manual.
Bank Up/Tuner Foot Switch
This foot switch will advance through the user banks of presets. Each
successive press of the Bank Up Switch will advance to the next bank of
presets. Once a new bank has been selected, the 3 available preset numbers
will be shown in the Display and the 1, 2, and 3 switches will flash prompting
you to select a preset within that bank. If no preset selection is made within 5
seconds of selecting a new bank, the GENETXa processor will revert back to
the previously selected bank and preset.
Tuner
To activate the tuner, press and hold the Bank Up switch for 2 seconds.The
display will briefly read tu followed by the tuner reference, indicating that the
GENETXa processor is in tuner mode. Begin by playing a note on your
instrument. The numeric display will show the note being played.The 7 LEDs
beneath the display will provide an indication as to whether the note is flat,
sharp, or in tune.When the single green LED in the center is lit, the note is in
tune. LEDs to the left indicate your note is flat and LEDs to the right indicate
your note is sharp. Exit tuner mode by pressing any footswitch. |