DVP-NS70H
(4)The Emergency history display screen will be restored6-5. IF CON SELF DIAGNOSTIC FUNCTION
soon.
1. IF-134 BOARD (IF CON) TEXT MODE
Emg. History CheckThe IF-134 board (IF CON) test mode is the IF CON self-
diagnosis mode. THe IF CON can diagnose the functions of the
Laser HoursCD999h 59min
DVD999h 59minIF-134 board that the IF CON controls. Normally, the IF CON
makes a serial communication with the SYSTEM CONTROL
1. 01 05 04 0400 92 46 00and operates following the commands from the SYSTEM
00 00 00 0000 00 23 45CONTROL, but in the Test mode, the IF CON operates
2. 02 02 01 0100 A9 4B 00independently from the SYSTEM CONTROL.
00 00 00 0000 00 23 45In the test mode, the following functions can be checked.
1. Button function
[Next] Next Page [Prev] Prev Page
2. Remote commander receiving function
3. SYSTEM CONTROL-IF CON serial communication
(12) Press - key, return to TOP MENU.4. Fluorescent display tube lighting check
- Grid check
6-4. VERSION INFORMATION- Anode check
5. LED control function
Information of firmware version.In the test mode, the main unit operates same as usual, except
(1)In standby mode, press [TOP MENU], [CLEAR], [POWER]voltage monitoring, communication, display of fluorescent
display tube, and LED control.
to enter Remocon Diagnosis Mode.1. The routine that monitors +3.3V (PCONT) of MV-046 board
is not provided.
(2)Select ?4. Version Information?.
2. The monitoring timer for serial communication with the
SYSTEM CONTROL is not provided. The main unit is not
Version informationplaced in the Standby mode, even if the communication with
SYSTEM CONTROL is normal.
Firm (Main) : Ver. xxxxx
Firm (Sub): xxxxx3. Display of fluorescent display tube.
RISC: xxxxx(Normally, display is mode following the commands from
8032: xxxxxSYSTEM CONTROL).
Audio DSP: xxxxx4. LED control.
Servo DSP: xxxxx(Normally, control is mode made following the commands
Sub CPU: xxxx
from SYSTEM CONTROL).
2. OPERATION OF SELF CHECK MODE
- Return to Top Menu
The Self Check mode is the function to conduct the basic test to
t2. OPERATION OF SELF CHECK MODE
(3)Press - key, return to TOP MENU.The Self Check mode is the function to conduct the basic test to
the FL display and DVD panel section.
2-1. Self Check Mode Transition Processing
At the AC Power ON after reset of IF CON is released, while
pressing with the MV-046 board are not connected to the
IF-134 board, or while pressing the x key on the main unit with
the IF CON in STANDBY mode, enter [RETURN] t [DISPLAY]
(or [SETUP]) on the remote commander, and the main unit transits
to the Self Check Mode.
6-3 |
ACEC
