DVP-NS15/NS51P/NS43P/NS53P/K56P
(4) The Emergency history display screen will be restored soon.6-5.IF CON SELF DIAGNOSTIC FUNCTION
Emg. History Check1.IF-144/IF-145 BOARDS (IF CON) TEXT MODE
The IF-144/IF-145 boards (IF CON) test mode is the IF CON
Laser HoursCD999h 59minself-diagnosis mode. The IF CON can diagnose the functions of the
DVD999h 59minIF-144/IF-145 boards that the IF CON controls. Normally, the
1. 01 05 04 0400 92 46 00IF CON makes a serial communication with the SYSTEM CONTROL
00 00 00 0000 00 23 45and operates following the commands from the SYSTEM CONTROL,
but in the Test mode, the IF CON operates independently from the
2. 02 02 01 0100 A9 4B 00SYSTEM CONTROL.
00 00 00 0000 00 23 45
In the test mode, the following functions can be checked.
[Next] Next Page [Prev] Prev Page1. Button function
2. Remote commander receiving function
(12) Press - key, return to TOP MENU.3. SYSTEM CONTROL-IF CON serial communication
4. Fluorescent display tube lighting check
- Grid check
6-4. VERSION INFORMATION- Anode check
5. LED control function
Information of firmware version.
In the test mode, the main unit operates same as usual, except voltage
(1) In standby mode, press [TOP MENU], [CLEAR], [POWER] tomonitoring, communication, display of fluorescent display tube, and
enter Remocon Diagnosis Mode.
LED control.
1. The routine that monitors +3.3V (PCONT) of MV-47/MV-48
(2) Select ?4. Version Information?.boards is not provided.
2. The monitoring timer for serial communication with the SYSTEM
Version information
CONTROL is not provided. The main unit is not placed in the
Firm (Main) : Ver. xxxxxStandby mode, even if the communication with SYSTEM
CONTROL is normal.
Firm (Sub): xxxxx
RISC: xxxxx3. Display of fluorescent display tube.
8032: xxxxx(Normally, display is mode following the commands from
Audio DSP: xxxxxSYSTEM CONTROL).
Servo DSP: xxxxx4. LED control.
(Normally, control is mode made following the commands from
- Return to Top MenuSYSTEM CONTROL).
2.OPERATION OF SELF CHECK MODE
The Self Check mode is the function to conduct the basic test to the FL
(3) Press - key, return to TOP MENU.
display and DVD panel section.
2-1.Self Check Mode Transition Processing
At the AC Power ON after reset of IF CON is released, while pressing
with the MV-47/MV-48 boards are not connected to the IF-144/
IF-145 boards, or while pressing the x key on the main unit with the
IF CON in STANDBY mode, enter [RETURN] t [DISPLAY] (or
[SETUP]) on the remote commander, and the main unit transits to the
Self Check Mode.
6-3 |
ACEC
