4 TrayCheck (Left) result display3-3. Voltage Check Mode
After tray check is completed by rotating it in the counter-clock-This mode checks the drive voltages of tray and table. Because the
wise direction, the following display appears.full drive voltage is applied to each motor in this mode, do not
execute this mode while the mechanism is being connected. When
### Mecha Check ###
this mode is selected, the following menu appears.
GuideSlit Time (Left)
21 : 1 �> 5 : 139,138 ms OK### Voltage Check ###
22 : 5 �> 4 : 138,137 ms OK
23 : 4 �> 3 : 138,138 ms OKRIGHT : MOTOR +
24 : 3 �> 2 : 139,138 ms OKLEFT : MOTOR �
25 : 2 �> 1 : 140,139 ms OKENTER : STOP
Exist Disc : 3_
Push Any Key
_
Exit: RETURN
The guide slit time (in units of ms) of each operation segment ofExit: RETURN
tray is displayed. In the right of the time display, judgment if the
time is OK or NG is displayed. The ExistDisc indicates the numberWhen [PLAY] is pressed, AllCheck starts.
where disc is located. This judgment of OK or NG is displayed on
the FL display tube. If the remote commander [UP] or [DOWN] keyWhen [RIGHT] is pressed, the positive (+) voltage is applied to the
is pressed, results of measurement of each operation segment aremotors of tray and table.
displayed on FL display.When [LEFT] is pressed, the negative (+) voltage is applied to the
When [NEXT] is pressed, result of the next measurement is displayed.motors of tray and table.
When [PREVIOUS] is pressed, result of the previous measurementWhen [ENTER] is pressed, voltage is stopped to be applied to the
is displayed. If any other key is pressed, display returns to the mainmotors of tray and table.
menu.Press [RETURN] to exit this mode.
In the TrayCheck mode, if any key is pressed, display returns to the
main menu.
6-26E |
ACEC
