http://getMANUAL.com
3-3-2. Error Codes
This unit has a self diagnostics function which detects internal
ERROR
abnormalities. When a problem is detected, an error code is
displayed immediately in the time counter block, and details of the AN ERROR HAS BEEN
error appear on the video monitor.DETECTED INDORM SERVICE
OF FOLLOWING CODE :
An error code can be displayed on a monitor by connecting a
XX-XXX
monitor to the VIDEO 2 (SUPER) OUTPUT connector, and by
PRESS EJECT KEY
turning on the CHARA. DISPLAY item on the SETUP menu
TO EJECT TAPE.
using the DISPLAY CONTROL.
Note : An error code appears in the column shown by XX-
XXX on the video monitor.
When detected, some errors turn this unit to AUTO OFF.
(See from page 3-14 of item O3. Error Codes�, excluding error
code 08-032.)
This error is kept in memory even after the main power of this unit
is turned off. In other words, the error code or the contents of the
detected error appear even when the main power of this unit is
turned off and then back on again, so this unit enters AUTO OFF
mode again.
The machine enters the emergency EJECT mode when the
[EJECT] key is pressed at this moment. In the emergency
EJECT mode, the tape is ejected gently by the motor (if working)
assuming that the tape is slack or a device may be faulty.
The following message appears on the video monitor when the
ERROR
machine enters the emergency EJECT mode.
The error code is displayed on the time counter.TAPE IS BEING EJECTED.
WAIT UNTIL THIS
INDICATION GOES OFF.
DSR-80/80P/60/60P
3-9 |
ACEC
