2-2. EXCHANGE METHOD OF BARRIER ASSY
Service parts
Part NumberPart NameQuantity1
12-673-650-01Ring (A), Ornamental1
22-673-652-01Barrier Assy1
32-673-651-01Tapping scre�w (B1.24)2
Tools used
Torque driver2
Soldering iron
W eight about 60g
Adhesive tape (ornamental ring fixed) (2-677-885-01)
3
2-2-1. PEEL OFF OLD ORNAMENTAL RING A
The Ornamental Ring A has adhered to the Barrier Assy strongly and accordingly, use a soldering irce.on to weaken the adhesive for
Heat four circled portions with the soldering iron.
Heating temperature is about 3001C.
Beware of a burn since the entire Ornamental Ring becomes hot.
* As the adhesive force of Ornamental Ring A is considerably large, the forced peeling will damage the group-1 frame.
Insert the tip of tweezers, etc. into a notch of the group-1 frame and prize the ring.
* Take extreme care so as not to damage the coated surface of the group-1 frame.
In case of difficult peeling, heat the ring again with the soldering iron.
If this re-heating failed, it may be advisable that the ring be peeled w1 ? 2 in the under fhile heating the portions igure one by one
sequentially.
* Discard the removed Ornamental Ring A.
1
2
Tip
DSC-W30/W40_L2
2-6 |
ACEC
