Supplied accessories
1 AC-L10 AC power adaptor1324
2 Power cor (1)d
3 A/V connecting cab (1)le
4 NP-FM50 Battery pac (1)k
56785 Shoulder strap (1)
6 Lens cap strap (1)
7 Memory Stick (8MB) (1)
8 Lens cap (1)
90qaqs
9 Bundle soft (2000) (1)
(Compact Disk)
0 USB cable (1)
qa 2-pin conversion adaptor (1)
E model
qs 2-pin conversion adaptor (1)
Tourist model
SAFETY-RELATED COMPONENT WARNING!!ATTENTION AU COMPOSANT AYANT RAPPORT
� LA S?CURIT?!
COMPONENTS IDENTIFIED BY MARK 0 OR DOTTED
LINE WITH MARK 0 ON THE SCHEMATIC DIAGRAMSLES COMPOSANTS IDENTIFI?S PAR UNE MARQUE 0
AND IN THE PARTS LIST ARE CRITICAL TO SAFE SUR LES DIAGRAMMES SCH?MATIQUES ET LA LISTE
OPERATION. REPLACE THESE COMPONENTS WITHDES PIéCES SONT CRITIQUES POUR LA S?CURIT?
SONY PARTS WHOSE PART NUMBERS APPEAR ASDE FONCTIONNEMENT. NE REMPLACER CES COM-
SHOWN IN THIS MANUAL OR IN SUPPLEMENTS PUB-POSANTS QUE PAR DES PIéCES SONY DONT LES
LISHED BY SONY.NUM?ROS SONT DONN?S DANS CE MANUEL OU
DANS LES SUPPL?MENTS PUBLI?S PAR SONY.
SAFETY CHECK-OUT
After correcting the original service problem, perform the following
safety checks before releasing the set to the customer.
1. Check the area of your repair for unsoldered or poorly-sol-4. Look for parts which, though functioning, show obvious signs
dered connections. Check the entire board surface fof deterioration. Point them out to the customer and recom-or solder
splashes and bridges.mend their replacement.
2. Check the interboard wiring to ensure that no wires are5. Check the B+ voltage to see it is at the values specified.
Opinched� or contact high-wattage resistors.
6. Flexible Circuit Board Repairing
3. Look for unauthorized replacement parts, particularly transis-Y Keep the temperature of the soldering iron around 270 uC
tors, that were installed during a previous repair. Point them
out to the customer and recommend their replacement.during repairing.
Y Do not touch the soldering iron on the same conductor of
the circuit board (within 3 times).
Y Be careful not to apply force on the conductor when sol-
dering or unsoldering.
� 2 � |
ACEC
