DSC-P51/P51M
2-3. SERVICE MODE3. Switch Check (1)
1. Setting the Test Mode
Page 2Address 80
Page DAddress 21
BitFunctionWhen bit value=1 When bit value=0
DataFunctionPOWER SW
00Normal0(CONTROLOFFON
SWITCH BLOCK)
02Forced MOVIE mode power ON
1
03Forced PLAY mode power ON
2
04Forced CAMERA mode power ON
SHUTTR SW
Y Before setting the data, select page: 0, address: 01, and set data:
3(CONTROL SWITCHOFFON
01.
BLOCK)
YFor page D, the data set is recorded in the non-volatile memory
by pressing the PAUSE button of the adjusting remote com-XSHUTTER LOCK SW
mander. In this case, take note that the test mode will not be4(CONTROL SWITCH OFFON
exited even when the main power is turned off.BLOCK)
Y After completing adjustments/repairs, be sure to return the dataMEMORY STICK
5OUTIN
of this address to O00�, and press the PAUSE button of the ad-IN SW MS Sock(et)
justing remote commander.
Select page: 0, address: 01, and set data: 00.
Using method:
1) Select page: 2, address: 80.
2. Bit Value Discrimination
2) By discriminating the bit value of dispaly data, the state of the
Bit values must be discriminated using the display data of the ad-
switches can be discriminated.
justing remote commander for following items. Use the table be-
low to discriminate if the bit value is O1� or O0�.
Display on the adjustilng remote commander
0 : 00 : 00
Address
Page
bit3 to bit0 discrimination
bit7 to bit4 discrimination
Display on theBit values
Adjustingbit3bit2bit1bit0
remoteorororor
commanderbit7bit6bit5bit4
00000
10001
20010
30011
40100
50101
60110
70111
A81000
91001
A (A)1010
B (b)1011
C (c)1100
D (d)1101
BE (E)1110
F (F)1111
Example: If O8E� is displayed on the adjusting remote com-
mander, the bit values for bit7 to bit4 are shown in the
A column, and the bit values for bit3 to bit0 are shown
in the B column.
5-39 |
ACEC
