Turning your camera on/offHow to use the
control button
The Auto Power Off function
POWER lamp
POWERIf no tasks are performed for a while* when
POWERshooting, viewing images, or setting up the
Program
camera while using the batteries, power is Auto
CameraMode
automatically shut off to preserve battery
power.
However, in the following circumstances,
Voice
even if the batteries are being used to power E-Mail
Burst 2
Normal
the camera, the Auto Power Off function
REC Mode
will not work.
Movies are being played back
, Press POWER to turn on the To change the current settings of the
A slide show is being shown
camera.camera, bring up the menu or the SET UP
A cable is connected to the (USB) jack
screen (page 45), and use the control button
or the A/V OUT (MONO) jack
The POWER lamp lights in green and the to make the changes.
power is on. When you turn on the camera For each item, pv/Vr/esb/Bs to select the
*When [Power Save] is set to [On]:
for the first time, the Clock Set screen desired value, thzen or preb /Bss to make
approximately 90 seconds
appears (page 21).the setting.
When [Power Save] is set to [Off]:
approximately three minutes
To turn off the power
Press POWER again, the POWER lamp
goes out, and the camera turns off.
Do not remove the batteries or AC
Adaptor with the lens portion pulled
out. This may cause a malfunction.
When you turn the power on with the mode
selector set to or , the lens begins to
move (DSC-P72 only). Please be careful not to
touch the lens.
20 |
ACEC
